Mike,
I recently moved and my tools were in storage in humid weather for a couple of months and I had no rust at all on the cast iron. What I did was to apply a heavy coat of paste wax on the cast...
Type: Posts; User: John Branam; Keyword(s):
Mike,
I recently moved and my tools were in storage in humid weather for a couple of months and I had no rust at all on the cast iron. What I did was to apply a heavy coat of paste wax on the cast...
I found my local woodworking club by searching online. You may also want to check and see if there is a Yahoo group made up of woodworkers in your area.
I actually was able to get this from my basement shop to the family room with just my wifes help. It is fairly heavy though.
Thanks everyone on the comments/compliments this is the first peice I...
I saw something simular to this at a high end store and thought I could build that. I designed it to fit my TV and room. The wood was from a pile that was sitting in someones drive exposed to the...
Try looking up David Marks on the DIY network site. He did an episode of Woodworks on building a smoothing plane.
Try looking a websites for some of the office furnitutre makers like Hons, and Steel Case. They mey have photos of different set ups.
I get most of my wood from Wilhelm Lumber in St Leon, IN. Just about 10 minutes out 74 west past Harrison. Reasonable prices and a nice selection.
I have had the T3650 for over 3 years and I think it is a very good saw. I added a router table and out feed table.
Thanks for the info on balancing the wheels. I will be upgrading the drive belt this weekend.
I just got the Ridgid bandsaw about a month ago. Lots of vibration.
Lance- How did you balance the wheels?
Very nice shop. However, it is far to clean;)
I have een searching in vain to find some information on making "holsters," for lack of a better term, to stor my cordless drills. I remember seeing this in a magazine but I can not find the article....
I have had the most success gluing on the solid wood piece to the plywood leaving it about a 32nd of an inch proud all around. After the glue dries I use a flush trim bit in my router to even the...
I have made 3 cabinets for my shop with MDF face frames and then painted them. They have held up just fine.
Very nice! I really like the look of the cherry.
I bought an adapter that goes from 2 1/2" to 4". I got it at Rockler and it has worked well for me.
Do you have a picture that you could post?
I have room for a free standing set up, but I am leaning more toward a wall mounted set up. I do not have a lot of wood to store right now but that will change this summer. I also want to incorporate...
I have just rearanged my shop and I am looking for some shop built ideas for lumber racks. I have see the triton system at Rockler but I would think I could build something for less than the $64 cost...
I used to work ou on the tarmack at the local airport and ear plugs really work better than ear muffs for me. So when I am in th shop I use soft insert ear plugs that are conected by a cord/band....
Check out a product called saniflo, it is designed for what you are looking for. It is a macerating unit.
Thanks for the replies everyone.
The dust collection on the ridgid is much better than most contractor saws. There is a shroud around the blade underneath the saw with a port that is set up for 4" hose or pipe, I also have a zero...
I am going to be building a bar in my basement rec room and I need some ideas for the design. If you have a picture of a bar you have built could you post it or direct to a web site that might be of...
This is not my saw but this is what used as the model for my router table