Search:

I have been under the assumption that PVC is a no go for engravers. Am I wrong to think that?

Keith,

If that's what you're thinking, then I'd go ahead and order a replacement attachment since they are on back order right now. Also, you could try engraving a heavier weighted tumbler to see...

Keith,

Could it be that the cup is slipping on the rotary attachment? I have engraved many mugs and this started happening to me a few months ago. It appeared that the grips that turn the mug when...

In December of last year I noticed a loss in power. If I increased the power, lowered the speed and went over the same spot multiple times, then I would get normal results. It bothered me that I had...

Tom,

I have the fix to your problem! Mike nailed it when he said to check and see if you have a bottom-up directional setting. There are two directions to choose from, top or bottom. You'll find...

Here is another Cermark trick that I use a lot when engraving on a rotary attachment.

(I'm assuming this is what happens) When I'm engraving on a rotary attachment and there is a break, or a gap...

Markel,

I re-laser over the same spot I just blackened and it burns into the material as it normally would.

Here is a good Cermark trick for anyone who doesn't already know. I use it at least once a week!

If you are unsure about where your laser will hit you can just engrave on top of the Cermark by...

Jay,

No, at least not the one we have. We use it to print on flat substrate up to 64" wide. That's not to say that there isn't a flatbed out there that is capable of doing that though.

Jay,

We have a HP flatbed. I don't personal run it, but any questions you have I can get my printer to answer for you.