Search:

Here are some photos of new dust hood I had made.286078286079286080286081286082286083

Thats the problem the oem breaks so easy. I was looking at a 4'' drain T that measures 13 1/4" w x 4" h if I cut it in half lengthwise it might just work and its heavy duty.

I did a complete break down awhile back and I remember I had the same issue. I will check my notes and photos and will post later.

Finally finished base on the Planer and now looking to construct a dust hood/chute and was wondering if anyone made theirs. Would like some ideas,photos. Thanks:)

Thanks Shane, I found info in parts list on line. M10

DC- 380 15" planer, thanks for thread.

Need help with identifying size of nut that secures elevation crank handle in place and also the key bar. Thanks for any support.

Thanks for info,by the way what would be a good height from floor to deck?

Thanks Don

I am working on a base for my DC-380 planer and came across some casters that were rated 175lbs each . would using 4 of these be ok for 400 lb load?

Thanks Michael, going to place in an order and started sanding the bed.I have a few score marks that looks like someone draged a few nails/screws across it metal must be soft.

update, made repair to screw nut only to discover broken sprocket and I thought I was going to be bored.

Thanks Michael,I started last night cleaning by hand as I don't want to disturb what is woking.I have to replace 1 screw nut,how difficult is this? Its the one located on the drive side infeed.

Thanks for info, you are right it is one heavy beast.I started the tear down from the top removing the motor then housing and all the rolls including the anti kick back knives.My outfeed roll is in...

I made the base for the 380 and noticed when placing the unit on top, one of the screw nuts was cracked. I have one on order, looks like a complete rebuild at this point. Anyone here rebuilt one and...

Let me see if I have anything on paper,the top and bottom frame are 2x3 the sides also 2x3 with 3/4" ply.The top & bottom center lines up with base of saw and I notched the plywood sides in flush.I...

To start with I shed the legs and design a base unit with built in dust chute,add some drawers ect..223735 hope this helps.

Thanks for replies,level of difficulty to tear down this unit? Tom, I like your stand may go the same way.
Gordon

Starting on another tool project this being a Delta DC 380 15" planer. I have to replace or have the outfeed roll recovered also plan to build a base for it. What would be a good and safe height to...

I used Valspar Tractor & Implement high gloss enamel # 4431-15 International Harvester White, from Tractor Supply. $34 per gal they also carry the hardner to reduce dry time and increase gloss. I am...

220314220315220316220317 I did not know how long it sat so I decided to break it down and give it a fresh look along with some fitting to square it back up.

I recently picked up a crusty Grizzly 6" jointer and tore it completly apart. Many hours later and near completion I realized that I forgot to mark the fence for tdc. What do I need to do to install...

Thanks for info, it has the 8" blade. I downloaded a manual sometime back. Will post pics once I make my mind up as to which one I am going with. again thanks

I recently finished a rebuild on a vintage craftsman table saw model# 103.23833 and want to update the fence and clamp. Any ideas or info would help.

Again thanks , I made the sock from some kevlar pieces I had around. As far as I can tell all craftsman. I will try and post on photobucket for clear details.I think I have more fun finding and...