Search:

The tube won't make a burn mark on mirror #1 but when i fire the laser the tube glows bright purple like i think it should and the mA meter shows 20. I put a large piece of cardboard right in front...

Thanks for your response Dave, I will look more closely for a crack

My laser tube won't leave a mark on mirror #1 and i can see a burn mark on the tube aperture (i guess that is what it's called) can someone tell if the tube is dead? Attached is a picture of the...

When I press the laser fire button I can see the the tube glow brightly but it does not leave a burn mark on the tape on mirror #1. The amp meter registers 20 amps when fired. Could the tube be bad?...

So I have replaced a defective x driver with one exactly as the old one. All wiring and settings the same but now the motor runs in reverse. Can someone tell me how to correct this.

Thanks in...

Sorry my mistake, I was told I could get parts for my gweike at rabbit laser therefore I just assumed thay sold this brand laser!

rabbitlaserusa.com

I have a 60 watt from Hurricane (gweike laser) that the x,y and z axis just suddenly quit working while back and still not working. You can get parts from Ray at Rabbit Laser as his lasers are gwekie...

Thanks Bill for your reply, I have checked the emergency stop button and the safety interlock. Not sure where the fuses are butt will try locating them!

So I was doing a beam alignment on my gweike 60 watt and all of a sudden the X,Y and Z axis's just quit working, no motion. Can someone tell me what might have caused this problem or what to look...

Thanks for your response Bill, yes I have a voltmeter.

329503329503329503329503Sorry for the same JPEG four times as this my first time trying to add a picture. This is the cabinet of my 60w gweike and i am trying to figure out what are the power...

Thanks Bert

Thanks Jerome

Thanks Dave

Where is the fuse located? I have a 60w gweike and lost power to the x,y and z axis. The mother board has lights flashing and the main psu has no lights on but the fan on it works. Does the main psu...

I was aligning the mirrors constantly moving the x,y axis around, could this have been part of the problem?

Hi All

So I was working with the laser and stopped for awhile and when I was ready to start up again the x axis would not move and then the y and z axis would not move and still doesn't. I heard a...

Thanks Walt I will give this a try

Rich, when the laser is on the y axis will move up and down using the control panel but the x axis won't move at all and I noticed the red light was flashing on the driver when the laser is on, so I...

Thanks Joe for your reply, I will check this out.

So I was in the process of beam alignment and the x axis stopped moving and when I move it by hand it is hard to move and makes a grinding like noise so just wondering if the motor may be toast? I...

Hi Rich,
May I ask how you do your alignment? My laser is actually a Gweike 60w I got from Hurricane Laser which is no longer in business.

Thanks.
Ray

I am trying to do a beam alignment on my Hurricane 60 watt laser but have run into an adjustment problem on the third mirror. When I shoot the dots I get one on top and one on bottom and when I move...

At Amazon you can get 8.5x11 and 12x12 mylar in 25 packs all thicknesses!