Search:

Brent:

You just may be correct.:)

I've probably confused the distributor with where it is manufactured.:confused:

Egon:D

The saw is made in Quebec,Canada by King.

The tensioning rod works well and fits into a dimple. [ not a hole ]

The blade runs at the back of the top wheel and the front of the bottom wheel....

Saw is four years old.

A staight edge shows the top of the top wheel as being back from the toothed side of the blade. It would appear either the bottom wheel or the top wheel be moved in/out for...

The wheels of my bandsaw are misaligned. Blade is to the back of the top wheel, to the front of the bottom wheel. 105 x 3/4 in. @ 3 tpi.

It is a 14 in. King three speed model with a riser block...

Very nice shop. :D

That is an interesting looking sawhorse.

Egon

Do a google search and you should find lots of examples.

Egon

You can do the same thing with pipe clamps and 2x4's .

Egon

Nice looking extension.

I made one for my Bandsaw but it sure doesn't look that nice. It has both infeed and outfeed folding tables attached to the saw.

Egon

Have you considered ripping thinner strips and glueing them together. Then finish off with a belt sander.

Egon

I do not have a table saw but have a radial arm saw.

Suggestions for table saw are :
Large very solid work surface with solid fences.
Easy to use adjustments
ability to mount a...

I have a Delta Sidekick 10 in. purchased from House of Tools. Happy with it.

But -- I would surely like the Dewalt 12 in. compound sliding miter saw. Have read good things about it.

What about...

I'm very happy with my Makita 3 x 21. Also works well when turned over and set on a bench for doing some types of work. Wore out one bottom plate/pad so far.

Egon

Check with the local RV dealer and find out what they use on their used units.

Egon

With the list of tools you have mentioned the bigger the better.

Perhaps draw a plan view and layout the tools too give you an idea of working room and separation required. Then go from there.
...

I belonged for a mounth. Got one book and then sent everything back. Refused to accept any further mail from them.

Egon

Wish you well on your endeavor Aaron.

I'm slowly getting set up to start building a few things but for retirment and home use only.

My only comment is to try and get power tools with the...

Can't comment on make of blade but would suggest that three blades may be the answere. The power of your saw may also come into question on the type/types of blades used.

One for rough cutting...

Are not cutting boards supposed to be flat?

Egon:D

The picture of the new Delta looks very similar to a sears 9 in. RAS I had many years ago. Moveved up to a sears 10 in. RAS and have been happy with it for 35 years.

Changed the table top to a...

The new tanks have a float controlled shutoff. If the tank is filled to capacity with cool propane and then taken into warm area expansion may keep the float up and close the vale. Similary with a...