Search:

Type: Posts; User: Doug Murray; Keyword(s):

Search: Search took 0.01 seconds.

  1. Replies
    8
    Views
    2,580

    I'm not getting any clicking that I can identify...

    I'm not getting any clicking that I can identify but I get that vibration I mentioned earlier. Once it is up to speed, I can feel some small vibration if I touch the housing but it isn't so bad it...
  2. Replies
    8
    Views
    2,580

    All clips are in place in the drum and I do have...

    All clips are in place in the drum and I do have balance weights still inside. Dan, what were the symptoms you were seeing with the bad spider? I'm only seeing serious vibration during spin-up and...
  3. Replies
    8
    Views
    2,580

    Performax Drum Out of Balance

    I bought an older (mid-90's) Performax 16-32 drum sander and noticed a vibration during start-up and shut-down. Once it is up to speed, I don't notice much vibration on the drum. I suspect it lost...
  4. Replies
    6
    Views
    1,167

    Nice shop, Sean. I'm in the middle of insulating...

    Nice shop, Sean. I'm in the middle of insulating my shop and wondering what to use for wall covering. It appears you used OSB for walls and ceilings. Would you do it again?

    Doug
  5. Replies
    68
    Views
    23,038

    Remain on SMC

    Mark:

    I second the previous post - stay with us. While I rarely post, I do enjoy reading your comments and responses - especially those that challenge a commonly held belief. And I learn from...
  6. Replies
    14
    Views
    1,915

    Increase the Tension

    I had the exact same problem cutting some 16/4 walnut - about ruined the blank. The blade bowed about 1" to the left in the center of the blank creating an arc in the cut itself. On research, I...
  7. Replies
    28
    Views
    8,782

    "....Yes, I have searched Craig's list and will...

    "....Yes, I have searched Craig's list and will continue to do so. Even If I do find one, the only way I have to get it home is in my van."

    Don't worry about transporting even an 8" jointer in a...
  8. Replies
    12
    Views
    1,281

    Biscuit Warning

    If you do use biscuits to align the two pieces (I usually do as well), remember to allow plenty of time for the glue to dry and the moisture to stabilize in the wood before finish planing or sanding...
  9. Replies
    7
    Views
    2,078

    Cracked Unisaw Top

    I just bought a 1986 Unisaw (at a good price) that has a top in need of repair or replacement and I need advice. The story I got is that someone apparently tried to pick up the Unisaw by the table...
Results 1 to 9 of 9