I use construction adhesive when I need a long assembly window
Type: Posts; User: Randy Rose; Keyword(s):
I use construction adhesive when I need a long assembly window
Milled up some 40 year old walnut planks
Wound up with 10pcs .875 x 8.5" x 48"
Nice work !
Not a fan of any of the electronic nanny devices.:p
I regret to say that my BX has hit the driveway exactly once this season.
A. I rather enjoy plowing
B. It`s a laborious task to remove the deck, install the plow, mount the weight package and...
^ Speaking of wedges, despite a 63" long table and my most careful efforts, some boards just refuse to be jointed into anything other than unusable potato chip shapes. Others seem to cooperate quite...
Cheese I can find, however what I can`t seem to source, is the eye watering, brow sweating, real deal , Chinese mustard to go along with it....
The large number reflects the price per dozen.
Well said.
The problem for pilots ( esp. jets) is usually:
" Running out of airspeed, altitude, and talent, all at the same time"
One assumes that they were going through the pre-flight checklist per prudent regulations
Being in the 500 mph aluminum tube of potential death at 30,000 feet is fine.
Being packed like a sardine with strangers for interminable hours gives me the willies.
Evidently a personality...
An innovative solution and very cleanly executed.
Exceptional work .
There is no end to the usefulness of Baltic Birch.
Nice !
Thank you for the "speed & feed" advice on plastics.
I am more afflicted with Q.E.D. ( quick,effective,dirty)
Recently purchased a #200 Jasper circle cutting jig to aid in a current project.
Nicely made, very accurate and very affordable.
When cutting the O.D. of the pictured discs I found that the...
Also. inspect the rails that the rollers ride on and "flip" them if worn
Leaving the original topic for a brief moment, your efforts appear to have yielded exceptionally beautiful results. Nice !
Same here.
Possibly the least credible "profession" that I have encountered.
Yet more sage advice ^ >
Buy one now, you`ll use it sooner or later.
It`s like a T/S or D/P drive belt, doesn`t cost much and best to have one "in stock"
Captain Obvious tip: please make sure your saw has sufficient arbor length to support the full width of whatever dado set you decide upon.
My Freud dial up set has a thick outboard flange due to...
A lot of sound and practical advice ^.
Thank you.
Don`t forget to budget a fair amount for the tooling and accessories.
Dedicated rip/crosscut/combination blades.
A dado set
Quality miter gauge.
Perhaps a Wixey DRO
Can`t tell you what to buy (other than bigger is better) however, I will offer what I would not buy again.
DeWalt D55168 15 gal upright
+`s low price / small footprint / on wheels/ runs...
A fair amount of work and expense but you would have an outstanding floor IMO
Mine is sheets of treated 3/4" T&G covered by 1/2" solid foam topped with 3/4" ply