Search:

Type: Posts; User: Lean Angle; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    681

    What finish to use?

    I've built and now stained a bench that has so far turned out great, but not I'm at a place I've never been before...

    I have to choose a finish for over the stain LOL

    So far all of the pieces...
  2. Replies
    11
    Views
    5,093

    I've been looking into DC lately, and I've been...

    I've been looking into DC lately, and I've been planning on putting the unit in a shed just outside my shop.

    I'm curious about the benefits of a cyclone when the DC isn't even in the shop. My...
  3. Replies
    63
    Views
    39,257

    I think that the issue is that it is very hard to...

    I think that the issue is that it is very hard to determine if you're getting a quality tool or not.

    I'm going to go out on a limb here and say that there is better chance of getting an inferior...
  4. Replies
    63
    Views
    39,257

    I know for instance that I don't usually bother...

    I know for instance that I don't usually bother to look when I buy clothes. I guess I'm not really as concerned about the quality, that and its almost impossible to find clothes made in this country.
  5. Replies
    63
    Views
    39,257

    Cars are very tricky. A lot of times you don't...

    Cars are very tricky. A lot of times you don't know where its made unless you check that particular vehicle's markings. And who knows where the parts were made.

    I don't worry about where the...
  6. Replies
    63
    Views
    39,257

    Where are your tools made?

    Anytime I shop for tools, I am pretty sure I pick up just about every one on the shelf looking to see where it is made. I more or less refuse to buy anything chinese, and I always try to find USA...
  7. Replies
    44
    Views
    4,817

    Just last week, I was building a lumber rack, and...

    Just last week, I was building a lumber rack, and glued up the supports facing the wrong direction. Boy was I pissed!

    It's not about being dumb, but sometimes you rush a little, sometimes you're...
  8. Replies
    39
    Views
    11,969

    I bought a craftsman 12" slider that I kind of...

    I bought a craftsman 12" slider that I kind of regret....and that regret is actually not stemming from it being a craftsman :p

    The slider just takes up too much room in my shop, and it is too...
Results 1 to 8 of 8