Thanks John,
I just need to see what speed it will engrave at now. My 1200x800 80w Laser uses LaseCut 5.1 & it engraves quite well at 900mm/s. This smaller machine seems as though it will not go...
Type: Posts; User: Warren Eames; Keyword(s):
Thanks John,
I just need to see what speed it will engrave at now. My 1200x800 80w Laser uses LaseCut 5.1 & it engraves quite well at 900mm/s. This smaller machine seems as though it will not go...
Thank you Doug. I was looking at the right item, but the number was up the top right, at the very back & I could not see it without putting my stronger glasses on.
Hello Doug,
I have RDWorks V8. In the vendor settings I have the "X" set at 600mm/s & the "Y" at 500mm/s. I do not have the "Default" ticked. I can not find a "maximum" setting in the "User" tab. ...
Hello John,
Thank you VERY much. It had to be simple to make me look "simple". I have the manual but I was probably looking through it with a blokes eyes (as my wife would tell me).
Once again...
Hello,
I have a 500x300 Chinese Laser as well as a 1200x800 Laser. On the 500x300 Laser does anyone know how to change the speed the head moves when you press the arrows (see attached picture)? I...
Steve I have just started to use CerMark glass colours (Australian spelling) Black, Copper and Blue. I am not having much success. I have an 80w Co2 Laser. How critical is the ratio as I put the...
Victor,
Thanks I will try that. I contacted the Lasercut software people but they were not sure if it could be used on X4. They said it was right up to X2 which I have not heard of. :(:(
I have Lasercut 5.3 and X4. Each time I try to load the Coreldraw file in the "Welcome to Use" box, Lasercut it says that it "Supports Coreldraw 11, 12 and X3. Does anyone know how to get around this...
Peck,
I am looking at a 120w-150w Laser. Could you tell me how your machine is with 120w power on Engraving ?
Regards
Warren
Janet,
I am looking at a 120-150w Laser and was wondering how stable your machine is? Do you do any heavy cutting with it/ and is it still good on Engraving.
regards
Warren
Mike,
Thanks very much for that.
Have you or anyone else had any experience with 120w-150w Chinese Lasers?
I am looking at getting a Laser that will cut 20mm Acrylic (the largest job at the moment) as well as good Engraving on 1.5mm Acrylic. I have been advised by one manufacturer that the 73mm Focal lens...
Pat at that rate the largest piece I would be cutting out would take about 1.5hrs it is 600mm long.
Has anyone else cut 20mm Acrylic with more than 80w power? If so could you please give me some...
Pat I look forward to your results. I am thinking I may have to go to a 120w machine.
Sandra,
You mentioned you have two Lasers. Could you let me know what the brands are and what is your opinion of them?
Warren
Thanks Buschy. Hope you have a safe time at sea.
James,
Thanks for your support. I must come to the conclusion that you and Rodne are so far the only replies from people not interested in selling.
I have had a lot of emails from the so called...
Rodne,
Thanks for your thoughts and opinion. Some good things to think on.
Warren
Has any one bought a 100W Chinese Laser Cutter? I am looking at the following manufacturers: Jinan Senfeng Technology, XYZ Tech, Guangzhou Yinghe Equipment, Rabbit, Sunnylaser. What success have you...