Search:

Type: Posts; User: Mark VoieArmour; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    1,965

    Sing it with me... I like big burls and I...

    Sing it with me...

    I like big burls and I cannot lie
  2. Wood is involved, and it was definitely a project. This was my Sunday.

    My Mother and Father in law had a cedar fence that ran along the entire back of their lot, about 80 feet worth, that was over 40 years old. It has been there as long as my wife has been alive. Due...
  3. Replies
    6
    Views
    2,325

    Thanks Sam, I was going to stain the poplar. But...

    Thanks Sam,
    I was going to stain the poplar. But I think I will just save it to make the legs for the next table, a full sized table, also for the same people. This was the learning table. I have...
  4. Replies
    6
    Views
    2,325

    Sam, Honest question. Would the poplar twist...

    Sam,
    Honest question. Would the poplar twist the center because it contracts on it?
    It was my intention to glue the sides to the Cherry center, and use an unglued bridle joint, T joint, or half...
  5. Replies
    6
    Views
    2,325

    Here is picture with the top sitting in the...

    Here is picture with the top sitting in the sides. In the upper left corner you can see the inset where the cherry portion of the top rests on the 48 inch edge. Which direction should I expect the...
  6. Replies
    6
    Views
    2,325

    Edge grain table top help

    I am currently building a 32x48 Cherry and Poplar table. The center is edge grain 4/4 cherry. First cut into 3 inch wide sections, 32+ inches long, glued together along the face, and ripped into one...
Results 1 to 6 of 6