Search:

I have had one for five or six years dead on accurate. You will like the T square > I have purrchased many items for them and pleased will all of theem >

I purchased the plan from Fine Furniture . Good plan , had full sze templates . Had to make a special mortise jig also from fine Furniture magazine on Jigs . Took me about a month to make both...

will post another picture after pa9inting and more detail of construction . My first photo up load and left some detail out.

I made 2 of thes out of Cypress

Getting ready to paint several cypress Lutyens Benches.Has any one used this sprayer and will it spray latex paint .

Just built the Mortise jig by Michael Fortune in the Fine Woodworking Magazine _ Shop Jigs ___works great but I would like to buy the clamps shown in the article but have not be able to fine them ....

Great Job..be sure to post a finished photo.

I have started to build two also, have the front and back legs conplete and will start on the crest rail cut out in the next few days . I have he Fine Woodworking plan also Not at all sure how to...

Built one a last year. Used Create -a- Bed turned out great --Follow the instructions to the "T" and it will turn out great . Will try and post photo's later

thanks for the reply ___ worked great

I am making a Lutyens Bench out of cypress . I cut out and used a pattern bit on router table with bearing on bottom to trim cut front legs. i am now wanting to flush trim the back legs and they...

I have used it , works great , not any problems . Used on Small cherry clock and jewelry chest of cherry and worked great >

I have two and use them all the time . Would not do without them .

Getting ready to glue a small section of veneer on to a 12" X 18 " piece . Top has a slight curve or rounded section . Do I need to use a special veneer glue or can I get by with Titebond.

I have built about 10-12 ad chairs , all have no finish just let them age with the weather

Ted , thanks for the info, will try and get back to you

yes the nut is loose

Have a PM 66 , about 5 years old. I have blown out dust with air compressor and used small brushs to clean and have oiled. It takes both hands to raise blade and change angle . Any suggestions

they have a tech No call 800-840-8420, I have called and they were a geat help

I have built one --- create a bed ____ don't rush a mistake can be very costly--- read the directions and review the DVD . I would not plan on having it built ,finished and installed in a...

I have built two . I used red oak and they finished out great .

trying to adjust the tilt on the saw is hard , takes both hands to turn the wheel. I remember awhile back a post about this , tried a search didn't find it. please advise. Mike

I too am building a queen size murphy. I am using create a bed design ,great plan and great video, good technical support. Will post pictures when finished.

count me in , sounds great mike

I have a shop fox spindle sander and have been well pleased ---excellent machine. Mike