Search:

Jeremy,

I had a 20" grizzly with their upgrade spiral insert cutterhead. I planed some painted boards (I know - kringe!) and some salvaged pine that turned out to have a few broken cut nails in...

Jeremy,

I hope that you have assumed that I have not seen this thread in a while and not that I was ignoring your question....No, I have not installed a steel plate as you have. Might I say, WOW!...

Here are the pics.

It helps to remove the outfeed side roller (jig roller, not feed roller) to install on the machine (faster than all the cranking).

The piece of angle iron in the pics gets...

Just a little note: when I wrote this post, I didn't have a properly loaded page, and it appeared that my post was the only reply. Sorry for any redundancies!

I have a used 718 and I also have...

James,

No, I don't get any slip with just one belt. A contributor on woodweb stated the opinion that two standard belts were required to compensate for inadequate tensioning. I don't know if...

Bob,


I've never inserted pics to this forum before so, if I did it right,
here are a couple pics of the motor mount mods:

72776

72777

I have small one man shop in central pa and space as well as price is always a major factor is my tool purchase decisions. Literally last weekend I took the family up to Manchester, Vermont to pick...