Search:

Try Wieland & Sons Lumber Co - they are in Winthrop, which is probably about an hour from Dubuque. I haven't bought plywood from them, but they have a good selection of lumber at good prices.

I'm currently making cabinets for my house and found exactly what we were looking for at Top Knobs. You have to order through a dealer, which they list on their site, but you can order samples from...

Thanks everybody - I appreciate it!! I think I'll order a couple from them. The pulls I'm going to get are in the $5 - $8 range (5" to 10" size). I'm not sure what "good" stainless steel pulls...

I need to order a kitchen full of door/drawer pulls and I'd like to find the same pull in different sizes. Does anyone have experience ordering from Cool Knobs and Pulls.com? They appear to have...

I have a Qualspray 2 qt pressure pot that I bought from Homestead Finishing a few years ago. I was using it over the weekend and couldn't get it to adequately pressurize. It's not the check valve,...

I'd also go with a 30 amp breaker. I've got the same saw on a 20 amp. Works fine, but I have tripped the breaker on start up when using a full stack of 8" dado blades.

Thanks everybody!

I believe the desired overlay (with the Blum 170 degree hinge) is a formula based on the height of the base plate (0mm, 3mm, etc) deducted from a fixed amount of 11mm, plus the...

Thanks Sam. It is a right angle, inside corner. I'm using kidney lazy susans.

The hinges I'm using on the other doors in the kitchen are 110 degree. If I use those, I think the doors would...

I'm building a lazy susan base cabinet for the first time and need hinges for the door(s). I'm building the cabinet with a shelf and will have lazy susans on each shelf, and I'm considering having...

Hey Everybody,

I'm in the middle of a kitchen remodel, and was planning on refacing an existing corner base cabinet. But as I was taking out the flooring and other cabinets, I decided to just...

After spending years being continually frustrated with screws snapping in half, I recently bought quite a selection of unplated steel square drive screws from McFeely's. I love them. They are so...

Wow - several hundred board feet of walnut? If you've been storing it for 10 years - do you have plans to use it in the future? Have you considered selling it? I know how difficult that can be,...

With my current kitchen project I plan to put 1/2" plywood down where the base cabinets, islands, etc will be and tile around that. Doing this allows the cabinets to remain at the proper height...

Thanks Jeff!!

I'm also in the process of building new kitchen cabinets. I pretty much buy all my hardware online from woodworkers hardware in MN, but I don't see these compact hinges with blumotion on their site....

Just wondering if anyone has replaced the drive belt on a DW733 - are there any tips to complete this?