Australian timber oil, according to their msds info is a mixture of linseed oil,solvent(mineral spirits) and varnish aka danish oil.
regards
jerry
Type: Posts; User: jerry mayfield; Keyword(s):
Australian timber oil, according to their msds info is a mixture of linseed oil,solvent(mineral spirits) and varnish aka danish oil.
regards
jerry
If you like the golden oak look apply a coat of orange shellac followed by an alkd varnish made with soya oil (stay clearer than most) McCloskey's and Pratt & Lambert 38 are two. Or just the...
Either Watco Original or Waterlox was first sold to schools as a finish for gym floors. Whichever it is,has a phenolic resin and tung oil. Phenolic is Very hard.
Regards
Jerry
If you use oil based grain filler (usually takes two applications for me) when you are through light sanding ,apply another barrier coat of shellack. I would use an alkd or phenolic resin varnish...
All danish oil is vanish,a drying oil and solvent.
regards
jerry
The first coat of any finish is a sealer. One " coat " of shellac, since each layer of shellac disolves the previos layer ther is in reality -one coat.Put on as much as you care to,when dry Lightly...
While i agree with buy them as you need them there are a few you can start with . Everone needs atleast one straight bit (i prefer spiral up cut) a round over bit(this is the most used router bit in...
with Jim's recipe you have a danish oil that will stay clearer than one made using polyurathane varnish.
regards
jerry
Shellack would work well on your table. I have used orange shellack on rosewood
and it turned out great. Don't be concerned if if the shellac has wax ,this is only a problem if you are putting...
The answer to your question is no. I personally like the look of orange shellac on walnut. If this is to be used in your shop you might want to consider a coat of an alkd varnish.
Good Luck
Jerry
You are absolutly correct about their tool reviews, but their so called finishing column where Bruce Johnson says he is answer questions by readers is utterly amazing. All of his solutions recommend...
I forgot to add another advantage to being connected to a starter is you can wire the remote contact is series with the starter coil. very low current flow and all power is removed from the motor...
While i agree that most,if not all, 240v machines should be conected to a starter, they also should be three wire control. If wired to a maintained position device and power is interupted ,for any...
how do you set up,shapenand use a veritas cabinet scraper?. i was recently given one and it isn't at all like the scrapers i've used. please help.
thanks
jerry