So I also have the Stanely #75. My question is what angle bevel to I put on the blade when I sharpen it? Its a bevel down blade so what angle edge do I give it and what should be the final angle of...
Type: Posts; User: Michael Hartery; Keyword(s):
So I also have the Stanely #75. My question is what angle bevel to I put on the blade when I sharpen it? Its a bevel down blade so what angle edge do I give it and what should be the final angle of...
Thanks for all the great feed back guys.. I am going to digest all of this and ill post back with some of the results. This ended up being a great discussion.
michael
OK Thanks for responding so fast. When I put a steel square of the edge of the blade I see light in the middle but it makes contact on the sides. Perhaps Ill try leaning on the left and the right...
Hello I have the NL standard block plane. After sharpening the edge of the blade comes out convex so the out side edges are higher that the middle of the blade edge. Shouldn't it be the opposite? The...
So I got my PM 60HH.
My out let reads 30A 250V.
I will have to switch out the outlet to receive the plug for the JOinter which runs on 230v. The circuit breaker for this outlet is 30a. Will I be...
This is all great feed back. Thank you
Does any one have any thing to say about the new Steel City Jointers with the granite tables?...
Yes you are right about that jointer . However I am considering the PM 60HH because of weight restrictions in my work space. The freight elevator is down and I will some how have to get the jointer...
Hello
I am thinking of investing in the Powermatic 8" 60HH helical Jointer for my shop.
http://www.rockler.com/product.cfm?page=24984
I cannot find any reviews of this jointer online so I...
I have this same joiner. I just salvaged it from my Grandpa's garage.
The beds are a bit rusty. Will that compromise the flatness of them?
Is it possible to have them re flattened?
Does any one...
Thanx for the feed back guys. Those videos helped allot. I made some progress with adjusting the frog. What angle would you recommend sharpening the blade edge to. I was told 30 degrees. Does that...
Hello
I have acquired a SW stanley no.7 joiner plane from my grandfather. It was used in his shop. Is there any where I could send this off to to have it tuned up? I need the sole flattened,...