I ended up buying a piece of 1/4” plexiglass and plan to make my own. The Woodpecker plate looks awesome but the cost plus shipping in almost as much as what I paid for the router. The 6-1 jig looks...
Type: Posts; User: Ed Gibbons; Keyword(s):
I ended up buying a piece of 1/4” plexiglass and plan to make my own. The Woodpecker plate looks awesome but the cost plus shipping in almost as much as what I paid for the router. The 6-1 jig looks...
Keep it in the shop for at least a week.
Just received the Bosch Colt router. I would like to purchase an aftermarket baseplate which is larger. Goal is to add stability. Suggestions appreciated.
Who do you send your blades out for sharpening?
My project calls for the dado to be 1/4” deep. Should I make it bigger to account for the glue?
Jim,
What gauge is your no name staple gun?
Who makes them? Are they worth buying?
What is the best overall blade?
I will be painting aluminum garage doors. Should I prime them first? Any feedback would be appreciated.
I live near State College, PA. Does anyone live nearby with a laser that I could observe the process?
Co2 laser I saw starts at $5000. That’s a bit more than I planned on spending.
I want to get into laser engraving. Looking to do wall plaques, etc. Research has brought me to xTool. What will I need? Hardware, software, etc? I’m willing to pay a little more because I have...
I’m using a router table to flush trim edges on a template. What would be the best and safest bit to use. I read some info about compression bits.
Not looking to go into production; plan is being a hobbyist. But I’ve learned that most times for a few more dollars, the value and potential is greater.
Looking to get into engraving on wood. Looking for recommendations on how to get started.
Flooded the area and wiped it off after 15 minutes.
How long should I wait to put an oil based topcoat after applying boiled linseed oil to pop the grain?
It is a small DeWalt handheld router that accepts a 1/4 inch shaft. I completely loosen the nut. Definitely want to keep metal away from the bits. Thanks for the feedback. I think I will take...
Even when I have completely loosened the collet, it’s very difficult to remove the bit. I need to use a flathead screwdriver to release the bit.
Suggestions appreciated.
I will be using a hand held router. I made a template out of 3/4 ply that I will place against a 3/4 piece of walnut.
Looking forward a recommendation for a flush trimming bit.
No problem. Just don’t want to use the incorrect paint and have future problems. From what I have researched, like all painting, it’s all about the prep.
Can regular paint be used for a bathroom?
On my Grizzly planer, I’m the middle of the top is a piece of plastic that impacts the depth of cut. Anyone
with this planer, have you removed the plastic?
474313
Definitely overkill on the grit sequence. I wanted to take off as much of the finish as I could without scratching the wood. Definitely the lower grits took off more but the higher grits appeared to...