Search:

I've had great luck with my Ridgid 16. It's not as quiet as the Fein but it can be hooked up to the exhaust and blow. It also has the drain plug on the tank if you have to suck up liquids. The Fein...

I just bought a left and right finger with the holes pre drilled and set up the jigs shown on the Leigh site. A very easy process, and I'm not sure that the purchased ones were required for...

Since you won't be using the old head, try drilling a few of the screws out. I think you'll find that the ones next to the drilled one will come out easy. Please be very careful using heat on them....

Hey Nicholas,
You might need to get an allen wrench that attaches to a socket. If necessary you can drill the heads off the screws to remove the blades (a must do when changing the cutter head). ...

I think my all time favorite would be "Water Hole #3"

One piece slate tables were very common for coin operated tables. The felt would be glued to the underside of the slate. Most of the time the slate would be covered upside down, and the weight of...

I've had the best luck with a drill press and a circle cutter. http://www.rockler.com/product.cfm?page=2393&filter=circle%20cutter Use the slowest speed on your DP and clear the shavings often.

What is the difference between these saws? How does one compare to the other?
I was looking at a used saw the seller thought was a Unisaw and other members have indicated it was a 36-750. I'd really...

If this is a Delta 36-750 where would the model # and serial # be located? What quirks did this saw have? I'd really like to hear from those that have or have used this saw.

Thanks Chris,
I haven't seen the saw yet. Any thoughts or idea of the value of this saw? Is this considered a fairly good saw? I have no idea when it was made.

Thanks All. I'll have him check the suggested places.

I'm going to look at an older Unisaw and would like to know where to find the model number and SS on the saw. The owner has looked but said he can't locate it. Where do they usually place these? Are...

As someone else suggested auto glass companies would be a good source for properly removing a door panel.
You might also want to try a car stereo installer. They would normally have the tools and...

Add me to the list.
Thanks,
Mike Dodson

I have the Rockler Jig and have had good luck with it. I think they all have somewhat of a learning curb. For the price, as others have said, it does what it says. The dust collector is a big...

Please add me to the list
Thanks,
Mike Dodson