Its looks alot like the Australian gifkins dovetail jig, try googling it , there are plenty of video's/demos online.
Type: Posts; User: Joe Zerafa; Keyword(s):
Its looks alot like the Australian gifkins dovetail jig, try googling it , there are plenty of video's/demos online.
How about a plug cutter?
How about Harold & Saxon, they are stunning.... http://www.haroldandsaxon.com/product-range/
Looks legit to me, bosch make a similar unit ... Bosch GTM12 Combination
joez
Hi Greg, the layout looks pretty good to me :)
In a smaller workshop they best way to get the most out of it, I find is to utilize your wall space. Get as much as you can off the floor and onto...
The TV show "According to Jim" that ran from 2001-2009 used to have a nice looking scraper plane sitting on a mantel in the lounge room, later on it looked to have been swapped out for a no 4.
...
I built the cart as per the MM yahoo forum that Norman mentions above, works really well.
I too have a Domino and use it 99% of the time, unless your working on large pieces and therefore in...
Was 45 ºC / 113 ºF in my workshop yesterday :( wish I could send some your way.
Joe
Can anyone recommend a source of measured drawings/plans for a slant top desk similar to the attached?
thanks
Joe
Hi Kyle, I have been thinking about the same thing for a while now.
Being a hobbiest, I dont make much, but sometimes after a piece I think oh that should have been a little...
Got them! thanks for your help :)
Joe Zerafa
I still need the instructions, anyone else out there able to help?
thanks
Joe
Hi Mitch did you send them through? nothings turned up not sure if its a problem at my end though.
Thanks
Joe
Wow that was quick! Thanks Mitch :D I'll shoot you a PM now with my Email Address.
Thanks
Joe
Hi All,
I recently purchased a Iturra Tension guage from another forum member, unfortunately the packaging opened in transit and the instructions fell out :mad:. Brian I trying to locate a copy...
Not sure if you can get them in Michigan but I use frontline panel clamps, dont think I can post a link, but if you google them you will find them.
Joe
Huon Pine, Figured Blackwood and myrtle are worth checking out.
The islandspecialtytimbers website is a good reference site for whats available.
Joe
Hi all, for some reason the conveyor belt on my 22/44 Pro has developed a kink down the center of it. THe unit is about 3 years old with minimal use.
Has anyone got any sugestions on a fix, is it...
I have been told electric wax pots (used to heat wax for waxing legs etc) make good glue pots.
Joe
I am speechless, RIP James Krenov :(
Hi all, i find cutting mitres on my saw (Minimax CU300 smart) a real pain, i was thinking about making a mitre sled for my machine. Now i have seen a stack of mitre sleds for traditional tablesaws...
Hi Jeff, sounds interesting any chance of some pics?
Joe
I always found with my rockler jig that running at the fastest speed and slowing the feed rate down makes a huge difference.
Joe Zerafa
Jason try using a few magnets to hold the bag inplace while you put the belt on. ;)
Joe Zerafa
A little off topic but has anyone cut tenons using their mortiser? Not sure if the lateral stresses would be bad for the bit?
Joe Zerafa