Why don't you usa a 30-06 cartridge on thelower half . The wood would streach further .
Ed
Type: Posts; User: Ed Snyder; Keyword(s):
Why don't you usa a 30-06 cartridge on thelower half . The wood would streach further .
Ed
You might want to try stewmac.com This is a great source for parts and also has kits. They also have a great catalog
Ed
Sam's club has a Bostitch round head nailer for $170.00 . Aleast they do around Buffalo
Ed
What I did was get a bolt with the same threads as the stopper and chuck it in the lathe. mounted the blank to that.
Ed
You might want to talk to Rob Lee. He might be interested
Ed
Are the rolling pins one piece ?
Ed
I used two sheets of plastic back to back and hung them from the ceiling. I then cut alternating slits top to bottom. Created the same effect .
Ed
What about a rubber rad hose
Ed
My Rigid bandsaw came with a sanding belt
Ed
Try liquid dish washing soap . I use it sometimes on my ski goggles.
Ed
It's almost the end of racing season. Should be a few enclosed trailers available .
Ed
And so close to home. I thought you could only buy clamps in pairs
Congratulations
Ed in Cambridge
Thanks Jim. It looks like it works
Ed
Just got back from holidays and thought I would share these pictures. A gondola repair shop
Ed
I am trying to post picture but when I select manage attachments I get "error on page" at the lower left corner of IE 6.
Any ideas?
Ed
There are still a few at HD on Galleria Drive in Buffalo area on Saturday
Ed
Had a question wheather you could use walnut for a cutting board. I thought it was toxic
Ed
Bob
What Are the overall dimensions
Thanks
Ed
I made a pair of these fences to-night ,installed a 3tpi resaw blade and cut right down the middle of a 4 foot long 4 inch wide piece of red oak. First real attempt at resawing
Thanks
Ed
The fence is machined that there is a 3 inch section on the outfeed side which is lower than the rest of the fence . This part sits on the outfeed table and there is a jap along the rest of the...
I have recently bought a jointer and have a question about the fence. All of the fence is above the table except a small section near the cutter head on the outfeed table. Is it normal for this...
I have a question about replacing a counter top. we have an "el" shaped top. What is the accepted way to cut the 45 degree angle where the two sides meet?
Ed