Search:

I would by a 50 over a 30 now

I ended up buying these they are very clear and not tinted everything looks like normal with a little dimming to them. http://www.lasersafety.com/eyewear/polycarbonate/p5m02/f31p5m025000

I have read a lot on here, seems there is some cleanup things corel can do but I cannot find them in the menus anyone know where to find them or access them??

I bought this tonight the new one 2017
Anyone give me a run down on proceedure to the fiber from an AI file and why you want to use it I so far feel it was a waste of money unless I am missing a...

I see mine are chinese and so I am going to return them as I cannot verify they are truely covered and CE cert.
I am looking at these they are 100% coverage at the 1064nm od8+...

Yes please let me know if the ones I linked in the op are covering the wavelengths or I should buy something else?

Thanks

these are for a fiber laser

So above the one guys says the lower side is missing is this the case??

So the ones that came with my Triumph laser gave me a head ache I do not believe they fully worked.

I bought these...

all good they got the new machine up and running works fast now no down time to mark2 or blips so far.

Ok I will see with they say I guess i can use it on 2 computers as long as they both are not online at the same time. I will try coping the files over too.

I bought a asus rog g751jy today to use...

I have this and a cd of the software trying to install it to another machine like several suggested. It is asking me for a usb dongle?? Never got that from triumph laser? what do I do?

I marked 4 of them perfect and started seeing the on a few later same spots. Did not stop while engraving but looked like the scan head got stuck and the popped the the next line. Is there something...

This is a brand new machine not even two or three weeks old and I'm starting to see the skipping of lines during a hatching and it's like it hangs and then pops?370297

What are your settings you use for this??

Thanks for tips on the triumph so far with my fine they are very helpful.

The price of their co2 flat bed system is cheap for sure.

One question I have is does it cut evenly across the bed or...

Looking with my SBA loan to buy a bed co2 system 100-130watts.

Recommendations??

If cheap enough I can buy on my Credit Card and was looking at any input on Triumph co2 bed systems if you have...

How do you guys strip the browning from your deep engrave on your 30watt fiber machines.

Do you use the laser with higher frequency and power or do you do it manually by hand.

Looking for a...

I need to hook it back up and retry been been busy doing other things did have some settings wrong from factory

I will check that tonight and report back

https://youtu.be/CpEwe9X-vTU

I have seen another menu online which prints a checkerboard pattern to enter measurements from to the software and then you recheck it after I cannot find it in the menus.

Of course I am using a caliper. I'm saying I set it at 80mm and the Image is stretched. When I did rotary text I had over lap also even though my text length was well below the diameter of the the...

or can some of you guys post their settings they use for doing cups and or items that size?

Also can you get results with out lines or distortion of the images?

I have, I am thinking my machine is not setup correctly and not calibrated to 1 to 1 in increments.

Thanks for the help I have spent all day trying to get this figured out. I set up with all lenses.
Currently I am marking a tumbler at 80mm dia if i do not do the split i can engrave the whole...