Search:

Not easy to take off, you will need a very small bearing puller, the pulleys are easily damaged, they are pressed on, no screw.

Terry, just out of interest, what speed do you run at. Bob Schmiede.

I have had mine for nearly two years now,been a workhorse,same tube. Made a few modifications like putting a gate on the intake exhaust grid to make it easier to clean the soot from cutting mdf, put...

If this has just started without problems before you will probably find that stepper motor is not getting full voltage. Taking the load of the stepper by loosening the belts will falsely give you the...

Stuart, Google lens digital.com how to add an ammeter . If still unsure get a sparky.

Nicely done bobby, the organic style of the box and wood used is very appealing.the cnc carving on the lid sets it off.i will try coffee grounds on my laser etchings,not sure how to apply them,but...

not a good idea, H20 in any form is not good for chainsaws,bandsaw blades are a solid mass, where as chainsaw chains a made up of multiple moving links,stick with bar oil,some run a lighter grade oil...

I use water soluble oil, one cup to a gallon of water, never any problems. Never gums up and keeps the blade clean.

Hey vic, I had similar language problem,went to my local chinese restaurant with all I wanted translated,George did it in a flash,all it cost me was a plate of dim sims,special fried rice and a sweet...

Take the honey comb off and put more ribs (support) underneath it.

Dan, when you have your file open on laser cut 5.3 ,as seen on your laptop, and it is ready to send to your laser m/c, you will press download,a pop up box will appear that has your last laser job on...

I have a ruler,part there of, glued to the frame of the machine between the up and down table so I can bring the table up closer to the lens to my prefered out of focus height. Ruler is vertical.

Could be your water flow sensor, if it is not functioning properly it will stop your laser from firing while everything else is working.

Red Dot should be able to help you out, feel your frustration Amos.

Amos,when I had my problem I disconnected the belts to take the load of the stepper motor and they would run, put the belts back on and they wouldn't run, not enough voltage going to the stepper...

Well done Bert, very nice. All the best from Australia.

​Amos mine did exactly the same,tried all what you said and after a lot of hair pulling found a loose wire,fixed.

""""....."...................

HI BERT, i use a product called algaefix, liquid form from the states. bought it from an aquarium shop. comes with a measuring cup and has been in my tube for about 8 months now, no algae. only needs...

Anthony, when you open the parameter box and it says enter password,are there dots in the password box. If there is enter your new parameters then press ok. Works on my generic 6090 laser.

Al, very nice creative work,like the bears.i have been chain sawing bears for a while now,but since I have had my laser have gone in another direction.find small items sell well,Buddha engravings on...

Hi tommy, I have a friend here in Australia who had the same problem. It was a loose wire on the stepper motor. Turn of the machine,follow the wires from the stepper motor down to there controller...

Hi Bec, the piece is about 40mm long and around the 20 to 21 mm wide,use they width.that's correct,put it on top of what your cutting,and and the laser head.up the table slowly,don't jam it in...

hi Bec,you should have a focus tool,rectangle piece of perspex. 21mm from the top of your substrate to the bottom of laser cone. that should give you a fine dot.do you have up and down table. bob...

photo of cut light grid panel.295244