Search:

I worked this up with a piece of scrap and yes all angles are 30 degrees. Now, on to the good stuff.

Now that I look at my drawing again that will probably work. Gonna try scrap first.

Two of the sides are longer than the rest.

It only goes to 45. I'm thinking set to thirty, cut those miters on the right and then move to the left side and cut the sixties.

I know I ask a few odd questions on here but I do appreciate the answers. Here's another one. I'm wanting to make a six sided box. Looks like it will require 60º angles. My question is, can you cut...

I usually use a branding iron on the boxes I make. I just made one that is too small for the iron. I am going to use an India ink pen. My question is, sign it before finish or after? I finish the...

I'm going to be making a number of boxes for a fellow craftsman. The boxes will have a sliding lid. I'm looking for ideas on the best way to cut a notch in the sliding lid for opening with your...

Thanks everyone. Looks like it will be epoxy.

Adding wooden scales made of Padauk to a flat stainless steel bottle opener. I'm going to drill the scales and opener and use aluminum pins to line everything up. Then glue pieces of holly over the...

Thanks for all the advice. I think I have decided to leave this one alone and try it on another one in the future.

The box I'm working on has box joints. The front and back is curly maple and the sides are purpleheart. Both are half inch thick. I would like to round the edges to the same thickness. I'm a little...

Most of my woodworking is making boxes. It's easy, I enjoy it and there is so many different things you can do with them. My question is, what would be the best way to round the corners on a box. I...

So you are saying the tube type grease and not the spray grease

I am currently assembling a Grizzly table saw I purchased and am to the point of cleaning the trunions and worm gears. The manual says to put lithium grease on them when they are clean. Should I...

I am having about 150 board feet of cherry sawed up and would like some opinions about air drying. I have seen some different ideas online. I saw where one guy even stacked it in his basement with...

Thanks, I will give it a look

I have a piece of sassafras that has a very appealing hole in it created by a knot that has rotted away. I would like to fill the hole with some kind of clear substance that will be very clear and...

Thanks, found the charts. I should have thought of those before.

I am going to drill a 3 inch hole for a clock movement using a Forstner bit. What speed should I be using on my drill press?

I have a friend that is a semi-recent widow that couldn't afford to buy her two teenage kids Christmas presents. She has them involved in the rodeo circuit and really wanted to get them some belt...

I think Jim is thinking of sassafras. It does look like it. I have used quite a bit of it.

Just gave me an idea for a slab I have been saving. Been kicking around different ideas for the base and now I have found it.

295882 This is one I made for my daughter-in-law who lost a baby at childbirth. She wanted one to keep the gown, cap and blanket the hospital gave her. It has a small brass plate on the lid inside...

I am making a display case from walnut that will have a walnut and Plexiglas top. The top looks like a picture frame with 45 degree mitered joints at the corners. The Plexiglas will fit in a dado...

Here is what the cradle ended up looking like.

293999294000