Unless there are a lot of windows in the basement you shouldn't have a problem. My shop has lived in three different basements so far, and the only neighbors that ever knew it was there were told...
Type: Posts; User: Dale Sandford; Keyword(s):
Unless there are a lot of windows in the basement you shouldn't have a problem. My shop has lived in three different basements so far, and the only neighbors that ever knew it was there were told...
+1 on the poly. I used polyurethane and a little wax on my MDF table saw outfeed table.
If you're using wood glue to laminate sheets of MDF the glue penetrates better if you very lightly sand...
I wouldn't worry about insulating the walls. I would paint the walls white if they aren't already painted. It will make the shop brighter, help seal against moisture, and make dust cleanup easier. ...
Sounds like powderpost beetles.
-- D
Since energy costs will most likely continue to rise, you may want to look at the the efficiency of your lighting. Here are a few generalizations about flourescent light efficiency. These are...
Just a thought:
If you can make an argument for blade stopping technology on a table saw that same argument could be used for planers, jointers, bandsaws, shapers, miter saws, etc.
-- D
40 minutes south on I-43.
:o
I've never had in problems with the collet on a Porter Cable 690 holding the bit. Perhaps there was some dust or debris between the collet and the bit when it was originally tightened. Under load...
For my dust collection system I sealed the length of the snap-lock with foil tape. Connections between pieces were made with three or more sheet metal screws and clear silicone caulk. If the pieces...
Can you switch to a gas dryer? Gas dryers usually only need 110V and can be run off the same circuit as the washing machine. That would free up the 220V dryer circuit for shop use. While not...
The MiniMax machines seem to come highly recommended. MiniMax would be a stretch for my budget, but I'd like to at least look at them before I make a decision. Anyone know where I could get a look...
Greetings all,
I've been lurking here for awhile. I decided it is time to join the community. I must say there is a wealth of knowledge being shared. My thanks to all that contribute to this...