Sure could. I think something changed in 2019.
Type: Posts; User: Dave Erickson; Keyword(s):
Sure could. I think something changed in 2019.
I posted what was intended to be a helpful thread on installing Byrd Shelix Cutterheads in Makita 2040 planers. I cannot see the photos, even though I created the thread. Now isn't that about the...
I think you are using a strange definition of varnish. Varnish is an old finish that predates polyurethane. aka spar varnish. It is made from a combination of linseed oil and other oils. ...
Thanks for the suggestions. I don't have a good place for spraying, so I will stick with brush-application. I like the way lacquer wears, it is just the problem with oily skin I am trying to solve....
What is the best kitchen cabinet finish to resist oily hands? I have been using brushed lacquer (DEFT), but I find that after 10-15 years of use the lacquer dissolves or degrades in areas that get...
Thanks for the suggestions re: speed and pressure. I ordered some new Fein pads and sandpaper and I will try them at a lower speed.
Dave
I've only had a multi-tool 6 months but it is fast becoming the go-to tool for cutting wallboard, trimming (both wood and aluminum) and sanding in corners, just about any job where clearance or...
Wood often has a mind of its own. Sometimes you need a fence you can push against. You can't do that with a Unifence. Even the Jetlock fence has a rear clamp and the ability to mount finger boards....
I used to have a Unifence on my Unisaw, but like others mention, it flexes since the end is not supported, and when cutting full sheets of plywood or wood with some mass (4x8's for door stock, or...
Byrd cutterhead ready for installation:
374305
Installing the cutterhead was just a reversal of the previous steps.
374307
I also decided to replace the drive gear for the feed rollers, to...
I have a job coming up which involves a lot of figured maple, so I figured (groan) I needed to upgrade my jointer and planer, both of which have served me 25 years, but which have always given me...
I have an original fence on my 28-345, so if you need any details PM me.