Search:

Type: Posts; User: Jack Parks; Keyword(s):

Search: Search took 0.00 seconds.

  1. Steven, I own a LT14SUV that I purchased from...

    Steven,

    I own a LT14SUV that I purchased from Woodcraft and I also got the mobility kit. You could save a few bucks using something like one of the heavy duty ShopFox mobile bases but the Laguna...
  2. Replies
    14
    Views
    2,566

    Justin, When I built my home shop it had one...

    Justin,

    When I built my home shop it had one interior light and receptacle and one exterior light and receptacle. I basically got my permit for a 32x40 storage building. After I got my CO I...
  3. Ronald, The best way for you to address this...

    Ronald,

    The best way for you to address this problem is to collect the dust at the source with a dust collection system. Also use a good vacuum with your sanders and other hand power tools. ...
  4. Dale's right you need to be able to drain the...

    Dale's right you need to be able to drain the tank daily since you plan to use it everyday. The easiest way to do it is to remove the drain valve and replace it with a right angle barbed fitting. ...
  5. Replies
    9
    Views
    1,719

    Bill, I agree with using a MM instead of a...

    Bill,

    I agree with using a MM instead of a chisel for many cuts. Maybe I'm chisel challenged or need to sharpen my chisels more often. I have the Fein Mini E-cut kit and use it frequently...
  6. Replies
    14
    Views
    2,566

    Justin, Congratulations on getting the...

    Justin,

    Congratulations on getting the dedicated shop. You will enjoy being able to just walk in and start working and when you get tired just turn the lights off and walk out. A couple of...
  7. If you have room to use two or more of the larger...

    If you have room to use two or more of the larger Magswitch magnets on your jig I don't think it will slip. It's amazing how well they hold. However, they are expensive at $35 each.
  8. I was worried about the screws collecting...

    I was worried about the screws collecting particles as well so I used the shortest drill screws that would penetrate both sections of duct. Mine has been in 5 years with no problems.
  9. The mastic tape has a foil backing.

    The mastic tape has a foil backing.
  10. Craig, Get you a Malco hand crimper and crimp...

    Craig,

    Get you a Malco hand crimper and crimp one end of the duct to look like it did from the factory then it will slip into the other piece. Then use three drill screws to secure the joint. As...
  11. Replies
    99
    Views
    47,323

    Peter, Thanks for the sobering reminder of...

    Peter,

    Thanks for the sobering reminder of what can happen when a 3hp motor throws a baseball size block of wood at you. I am glad you are OK and it did not cause a more serious head injury. ...
Results 1 to 11 of 11