Search:

I have started to use EasyDraw for Mac. It saves in DXF format for Lasercut 5. When I export as DXF. I have the following options for the format. AutoCAD R12/LT2, AutoCAD 2000/LT2000,...

Thanks. This is typical of me...

Umm, umm, umm somebody forgot to turn on the cooling pump. I got everything turned on and ready then realized that somebody must have forgotten to turn on the water. I am should fire the...

Hi Scott, yes you are right. I am in the process of trying to figure out what to do. I have sent out feelers trying to get some professional help here on site. It is very difficult. If it continues...

342970342971I think I will get nowhere unless I try to replace the power supply. I have contacted Matthew Ma of D-Win 3 times without acknowledgment. I have been searching for the correct power...

Dave, you have been very helpful here. I can't tell you how much I appreciate it. I now feel as though I might find a solution. (If not there is going to be a cheap laser on the market soon.) Thanks...

Thanks Dave. I will research "Door Switch". You have been a HUGE help. Best regards to you.
Len

Wow, thanks Dave. This thing is getting out of my league in a hurry. Where are you located? I have a feeling this thing could become very unmanageable for me. I will try to continue with this. I...

Yes I did not know what an ammeter was. The built in ammeter shows no dial movement at all. I guess it means the power supply is dead. Thanks.

Great idea. Thanks.

Thanks for this Dave. Very helpful. I will look at it. I will avoid the tube test thanks.

I must admit that I can't answer your questions. The power and speed ratio has not been an issue. The power has been pretty consistent. Most of my laser projects are pretty repetitious and I have not...

Thanks so much. I will try to figure this out. These ideas help.

Thank you for the help. I need to learn more about this.

Thanks Mark, I know so little about this that I can't even answer your questions. I only use it in Vector mode lately. By no cut/burn I mean that there is no laser beam emitting from the lens even...

Hi folks,

I have a 5 year old D Win 80 watt laser engraver. Suddenly there is no cut (burn?). The carriage follows the program as if it is cutting but there is no cutting beam coming from the...

Thanks Dan will do.

I have a D-Win 640. 80 watt laser engraver. 600 by 900 mm table. The 6 inch exhaust duct that came with it is really cheap and thin. The exhaust fan creates enough suction that the hose collapses...

Thanks Lee.

Thanks George.

Thanks for the tip. I meant no disrespect.

I have had some difficulty engraving dense exotic wood. Ebony and rosewood in particular. An fellow luthier said there is a product similar to a skin or membrane that facilitates having a clean,...