Although it would detract from the look, I would figure a way to reduce the chance of unauthorized removal from the cabinet. One way, although ugly would be to place a steel rod through the sides of...
Type: Posts; User: Abe Low; Keyword(s):
Although it would detract from the look, I would figure a way to reduce the chance of unauthorized removal from the cabinet. One way, although ugly would be to place a steel rod through the sides of...
Poplar is fast growing, sustainable, etc
Depending on the finish you use and your expecations, poplar will do just fine. A gloss finish viewed by side-lite might fail the test if not backed by tool steel.
While the persuit of...
Also check that there isn't a missing limit bolt. There are adjustable limit bolts to zero the trunion travel for 0 and 45 degrees. I'll bet there is one to limit the amt the blade can be raised.
I have been using a G. shaper for many years. No problem with the motor. Grizzly doesn't get all the high marks from visitors to your shop but doews get the job done. I have a Unisaw with a 3hp...
They are considered to be dangerous because they tend to come toward you when cross cutting. In Europe RAS blades have a negative tooth pitch to reduce or eliminate this tendency. I have an older 12"...
Sensitive nose
The suggestions are all great but my nose is still sore. I knew when I did it that I was not being very smart - but I had done the same thing several times before.
Two things were different this...
I have been aware of the dangers of fine particles for several years before I met Bill. Bill has done wonders to spread the word in a way that makes the data believable. Everyone has the right to...
Bandsaw Kickback
Yesterday I found a 3" x 6" maple oval 2 1/2" thick and decided it would make a nice bandsaw box. The first step is to cut of the top. I knew I would have to hold it firmly as the part of the oval...
I got a great buy on some hickory and after making some boxes I now know why it is used primarily as axe handles. :D
Your chest is fabulous. And you didn't complain even a little about the...
[quote=Wes Billups;637436]I have a few questions regarding 6” PVC. I purchased all of the ASTM D-2729 6” PVC I need to connect my tools to the cyclone and have a few questions as I’ve never used 6”...
My shop is unheated but being retired, I can wait until the sun warms it above 45 degrees. If I needed to have it heated I would still have the cyclone outside to reduce noise and increase interior...
The title says it all.
I couldn't begin to do the scientific comparison done by Bill Pentz and the analysis in the above posts but.... All I need do is check the ultra fine dust that accumulates over the long time periods...