Congratulations for new machine !
Type: Posts; User: Lucy Lee; Keyword(s):
Congratulations for new machine !
1)Would a 15A outlet be OK? not sure for your question.
2)we need a ground wire
3) There is a silicone sleeve that I assume slips over the entire tube to help prevent strike on the red wire. Am I...
CO2 laser can't cut aluminum,no mater which power , in another way ,if you use a magic powder
If you choose Chinese laser machine ,60w is better on the photo engraving than 80w and with more compatible price
From some points, the bigger laser power works with small power laser tube , the reverse will be forbidden, so your Z6 power with 80w tube ,it can although it is not the best
For a normal CO2 laser tube, even you not use it ,just in stock, there is little leakage, but it maybe not loose power suddenly, except there is some broken
Yes, first to check any wires loose ? if mo loose ,then use computer to control machine, if this can work,maybe the LED is something wrong or the worst the card with problems
If buy from China, the freight will be high and total will be about USD500 too
295058I s this kind of silicon? if so, it should can cut
The laser cut 5.3 seems not be compatible with the WIN8, ,but win7 64 bits will work
If need drivers, please visit our website to download,
If without motorized up&down. the laser head, can be adjustable about 3cm or so ,so if you want thick materials, needs motorized up&down ,
Hi Bill,
If 6mm or 9mm acrylic, would suggest big power
If door leave wide open ,you should make the magnet on the safety switch. and Chinese time usually is from 9:00-17:00 ,Chinese time(East 8 Zone )
Dear,
I am not sure about this software, but if our laser cut with something wrong in different words, we usually reinstall the software, it will become normal. does this make sense?
Best Regards
we would like to suggest he fiber laser ,it is with faster speed ,while the YAG one seems out of the market ,besides this one ,the diode laser marking also is popular
seems CO2 can't work on the raw aluminum,
Hi Janis,
Welcome to China,Welcome to our G.WEIKE
Best Regards
@Ken Smith Jr,
if for reci brand, laser tube diameter all same is 80mm,so no need to change the tube cradle. but now reci laser tube upgrade to Z series ,no w series again, and for the money, it...
@Ken Smith Jr,
If you upgrade the laser tube ,of course the laser power should be upgrade, and the tube lenghth also diffrent, 80w reci is 1200mm,while 100w is 1400mm
Hope this can help you
...
All machine with Led Lights inside,
red dot- two kinds, laser head one ,combined one (big laser power will not suggest ,cause seems it will loose the power )
Auto focus--most customer will choose...
Hi Frank,
How about your laser power? and for wood ,marble engraving ,will you engrave photoes or just words
Best Regards
1, yes ,In China,80w laser tube ,brand like reci , efr,warranty is 10 motnhs, tongli warranty12 months.
2, for samll engraving ,80w or 60w both ok.
3,DSP controller and stepper motor for hobby is...
@ Clark Pace,
the biggest possibility is the electrostatic interference
Best Regards
Hi Kay,
We will not suggest for a three-years-old laser machine , ,all of them are out of warranty ,especially the laser tube , already dead . this will cause many problems.
Try a new one from...
Hi John,
Yes, first ,take off your mirrors and lens ,make it as clean as possible
second ,if not work, then think about the laser tube may losse power
These two points are more important
...