Thanks all for the great tips and info!!!
Type: Posts; User: George Hoppen; Keyword(s):
Thanks all for the great tips and info!!!
I built a cross-cut sled more than a few years ago, with an adjustable mitre bar. It sits unused against the wall in my shop becuase I cannot get a runner on it without it binding or being wiggly,...
Terrific and quick feedback all!! Thanks a bunch! Happy new year!!!
Thanks Alan - I checked out website and they have some good stuff. Also - for those not familiar, cold rolled steel is dimensionally much more precise than hot rolled. Also like the idea of routing...
Yeah - duh on my part!! Counterbore holes in jig - thread bolts into bar! I've done that before! Thanks for the noggin joggin!!
Thanks for the tip on the cold rolled steel! I like that idea a lot. How do you attach it to the jig? Flat head screws countersunk? If yes, what tricks do you use to ensure the alignment of the...
I only have it riding in one slot, to the right of the blade so the jig is supported well. Thanks!!
It's been a while since I checked the width (over a year - been a little busy!), and I don't recall how I did it. I will check it again. Thanks!
I've made a jig for cutting panels between than 10" and 18" or so for my table saw. However, I cannot get a miter bar attached to it so the jig doesn't wiggle at all. I've tried an Incra miter bar...
Doesn't the static pressure capacity of the dust collector's fan play a significant role in its ability to pull in dust or chips? A 400 CFM fan with a static pressure capacity of 1" will not be able...
Thanks for those ideas. I will give it a try.
I made a cross cut jig to help me cut square (or mitered) ends on wider panels on my table saw. I first used an Incra miter bar on the jig that has 2 adjusting screws to fit the bar to the table...
This sounds like something I would try, spend 6 - 9 months making it, then (possibly) finding it's a little off, so spend another 3 - 4 months fixing it, and in the end the cabinet drawers never get...
I am looking for plans for adirondack style bar stools. Any help would be appreciated! Thanks!
I am looking for plans for this planer stand, from Shopnotes 91. What I have has the material cuts sheet, but I would like a little more detail on how it goes together. I believe it used to be...
Thanks - all make sense and are a big help!
I have a number of questions about zero clearance inserts for my table saw. A year ago I bought a piece of 1/2" thick phenolic to make several inserts for my 1992 Delta table saw. Well, as luck...