My concern is there are only two screw holes in the bottom. The two other elongated holes each have a guide rail/pipe directly beneath them. Not sure if I could get a nut in there to accept a bolt....
Type: Posts; User: Ken Taylor; Keyword(s):
My concern is there are only two screw holes in the bottom. The two other elongated holes each have a guide rail/pipe directly beneath them. Not sure if I could get a nut in there to accept a bolt....
It does Keith. The front face is setup to mount a hardwood face with 4 screws so no issue there (I'll probably use maple and a couple inches wider than the iron face). But I'm afraid of dishing by...
I inherited this Toles No. 20 vise from my grandfather and am trying to figure out the best options for mounting to my yet-to-be completed bench.
The bench top is 3.5 inch thick laminated southern...
Keith-
Is your blade in backwards? I did that once and boy it burns the hell out of everything, pine too! And it don't cut worth a crap either!
A rookie mistake but.....it happens.
Just...
Are you sure the face of the fence is perfectly flat along its length?
I had a weird problem with a new PM2000 TS 2 years ago see my post from 5/6/2008). Turned out that the back of the fence had...
Jason,
Still new to most of this, but I had a similar problem when I switched my TS blade... burned like hell...
Stupid me, I put it in with the teeth facing backwards!.
Worked just fine...
I have my PM 2000 wired to a dedicated 12/2 20A wire to a 220/20A breaker (double). Running like a champ!
You're right, the motor sticks out to the left on the PM2000 when the blade is vertical. Also, in this position the blade is to the right of the motor as you face it from the front.
BUT, as you...
Pic 1A is from the underside of the fence. the top white subfence was kicked out (up from this perspective where it sat on the weld.
Pic 3A is looking down on the weld from above. Can see its...
All-
Powermatic is replacing the fence as I write this. Bad weld is not my problem ..is theirs and they had no qualms replacing it. In fact I get to keep the old one. Maybe a flat file on the bad...
All,
I took off the subfence (the white plastic facing) to check out Franks' suggestion about the slot holes being too close.
What I found instead was that the weld where the fence arm meets...
Thanks for the ideas all, and what Frank is describing sounds like it explains what's happening. I'll check it out today.
If it was the back end of the fence I might not have noticed it, but being...
Hey, I'm new to this but diving in full bore.
I "just" purchased a Powermatic PM2000 table saw and have found the front end of the fence (the end nearest you) seems to be either bent or otherwise...