Search:

Glenn - if you have the time I wouldn't mind seeing a little bit more about what you've built around the lower guides. I assume its just 3-sided?

Thanks~
...

+1 and another thing:

Look at Germany and ask yourselves how is it they have maintained themselves to be an export powerhouse..with a still growing economy...while the US has not?

Could it be...

Jason,

Bet you're giving that stove a workout now! :D

Progress report?

Hey Congratulations Jason! You'll have to give us some pics on the install.

http://www.senco.com/con_rem/ViewTool.aspx?toolid=175[/QUOTE]

they have that one at my local Costco store fyi for ~ 139 with a brad nailer

Jason,

Over at talkFestool there are a number of members that have used this bench.

Walko at TalkFestool

the link is just a search on Walko over there...you'll have to dig a little for more...

Dave, I'm sure you'll get a lot of posts on this, so I'll just relate my experience.

the 150/3 is a great all around sander...you can pretty much control it with one finger...its quiet...and of...

Thanks Shawn...the dados are 5mm which left approx 8mm for the center portion...except for one little mishap due to my negligence they all remained intact :-)

I haven't attached the uprights to...

Just wanted to follow up on this thread. Thanks for all the advice, both here and in other threads :)

I ended up going with cherry ply...and dado'd the standards for the shelves...Fastedge was the...

John: I'm not certain...but I think my cheap ply had cats in it...at least that's what it sounded like while i was cutting :D

Shawn: Thanks for the tip...I think I have a plan...

What do you guys think about drilling holes (ala 32mm spaced holes) and just using shelf pins?

Shawn,

I'd thought of that...what I actually did was cut the dovetail 'channel' across the piece of ply prior to ripping the ply into three pieces...that was pretty simple and easy...no...

Hi,

I built some garage shelving similar to the sketchup drawing using sliding dovetails for the shelves. Everything went together 'ok'...but along the way I had a couple of difficulties...good...

Hearing your ideas was very helpful...Jamie, thanks especially for the thought provoking drawing...I seem to recall in an earlier life that Bondo works for everything! ;)

Jamie that is a very nice solution with the router jig...and it took me several readings to picture exactly what you wrote. I think I get it :)

Your jig would cut a circular arc/cylinder, but when...

I understand bricklaying some MDF...and even the laminations, but those mitered joints would kill me!

Perhaps one could cut all four sides simultaneously, miter and then laminate?

Hi all. I saw this pedestal and can't imagine the easiest way to create it. Would it be steam bending or building it up with multiple cut pieces of mdf? I am not planning to build this...was just...