I would like to thank all who replied. I will try it. Sounds like just what I'm looking for Thanks again:)
Type: Posts; User: Richard Ferment; Keyword(s):
I would like to thank all who replied. I will try it. Sounds like just what I'm looking for Thanks again:)
I am geting ready to order some USL from target coatings. I was thinking about ordering a gallon of HybrVar Alkyd varnish. However I have never used this product before. Can anyone give me some...
I have been using the Poly type belt for about four years. The sandpaper belt that came with the sander lasted about five mo. I don't use my sander every day,but I have had no problems with the Poyy...
I have now used Infinity blades in the DW735. I can only comment on my own experience. I am makeing two art & crafts night stands, and two art & crafts chest on chest with QS white oak primary soft...
Good evening, hope everyone is well.
I have a question. This weekend I am going to pick up 275bf of QSWO rough cut kiln dried. I am planing to bring it all into the shop to...
Both soft and hard maple are quite hard. You stated you wanted to use soft because it is less costly. Then you are going to have sticker shock when check prices on curly maple. Around here in North...
Wait untill you need to replace it . It might not need it. The sproket that usualy breaks is the drive.for the rollers. On the left side of the unit is a small bkack box that covers the drive chain...
:confused: I am new to spraying,like never done it before. I have a HVLP 3stage turbine I bought in March, I need alot of help. I am ready to finnish a bookcase 72 X 32 X 13 dyed brown maple....
I am looking for some feedback on the Infinity blades for my DeWalt 735 The blades from DeWalt don't realy hold up very well. From what I hear the Infinity blades are said to be made of harder or...
;) The light marks on the sides of the boards are the ray flecks white oak is known for. I am assuming the oak is flat sawn. That is why the flecks ade on the sides and not on the face as it...
:)
I have just completed a Blanket chest made of White oak ply. with all edges and moldings of Black Wallnut. I will wait untill final finish to do the aromatic red
cedar bottom. I have done...
:) Plans Now hea a free downloadable plan for a lingerie chest. they look prety good. I made two.
I was planeing some stock on Sunday for a corner cabinet. I had about 1/16"to go when I heard a thunk! The infeed and outfeed rollers stoped dead. I took the cover off the gear box on the left side...
:) Hi Bill, I am by no means a expert on finishes, however I have made a few projects with QS White oak. Dineing Room Table with 4 chairs, Stand alone Book Case, Craftsman Style Futon Frame, and a...
I have them. I hate them. One is higher than the other three. No adjustabilty. I still use them but without the magnets. I put the springs back in and adjust the old fassion way. :( IMHO they are...
I only own one Grizzly machine GO500 8" jointer it has a 4 blade cutter head and a 75" table the long bed realy helps out on long pieces. I realy like it. It has plenty of power,and cuts smooth. A...
:) If you get a 6 in. you will probaly kick yourself later.As for room, put it on a mobil base then you could move it around to acomadate the car. I myself have a Grizzly GO500 8in with 75in...
I have used both, they both cut nicely however IMHO the woodslicer leaves a smoother finish. :)
:) TS Powermatic 64
BS Delta 14"
CMS Delta 10"
RAS Delta 10"
CS DeWalt :)