Search:

The finish recommends 24 hours of drying time and I'm allowing 72.

The problem could either be the sealant isn't being fully removed with the stripper\sanding and the finish is just wiping...

Hi all,
I'm having a problem and I need your help. I'm refininshing kitchen cabinets and having problems brushing the lacquer over the finish.
This is the procedure i'm using...
I'm stripping the...

I have a Ridgid 12" miter saw and I'm very happy with it. I came with a blade and laser line. The blade wasn't great but it is accurate and the price was right.

The worksharp is super easy to use for chisels and lathe tools. It gets a little trickier with blades that are sharpened on both sides but this machine will get the tool scary sharp.

I love mine and it's very easy to use. I highly recommend it. Don't forget the leather hone.

how about calling the supplier directly. I've looked at that model and have always assumed it moves...

Thank you Charles but I don't think an evaluation is needed. I'm not knocking the blade...I recognize the Freud makes one of the best blades on the market. This one is not good but the problem is...

spinning the blade with my hand...I went out and bought another cheaper diablo Freud blade. This one is definatley straighter. I did quick measure and it looks like .003-.004.

Hi all..and thank you for the comments.

I cleaned the arbor and flange and blade area with steel wool and the runout was about .0015 so I'm guessing the blade has an issue. I'm thinking that...

Do the manufactures post this information on blade wobble? I have Freud blade that wobbles to naked eye. With a dial indicator it show about a .025 wobble.

This seems excessive to...

it certainly suits my purpose...or did. I must be growing beyond it's ability and my patience is certainly wearing thin.

I was able to hang the motor on the saw and it did pull the alignment out by a good .020. I worked with it for couple of hours but the closest I could get it was .006-.007 out at the rear of the...

Excellent...this is the kind of information I'm looking for!

I don't understand how a torpedo level would help align the bars...wouldn't it be measuring if the table was level?

I'm trying to...

So I tinker some with the nightmare and I have the alignment pretty close...the only problem is that I've done all this without the motor hanging on the pulley so I'm sure that will pull it out of...

Thanks all! I appreciate the comments.

the pieces in the pics pivot when the lean the blade. The bars attach to what the manual says are trunion brackets and the brackets fit in a groove that allows the saw to pivot. There's too much...

Hello!

I have a problem and I need some help aligning my TS. I have a Grizzly 1022 contractor type TS. I recently purchased a dial indicator to help me align the blade to the miter slot. ...

Arrived yesterday and it really sucks!

Thanks for the all the great information on this. This has been very helpful but one more question.

Is the setup for a timberwolf blade the same as any other blade?? I've heard different...

I'm looking for a bandsaw blade setup tutorial. Something regarding the blade tension and blade drift setup. Is one available???
Thanks!

very nice!

Hello,
I'm new to Incra system and I've been playing around to learn how to use this tool. So far so good but I want to know if it's possible to use one of the templates and an 9/16" x 7 degree bit...

Can't speak toward the 8" version but I just bought the 6" and its great. Snagged it on sale and couldn't be happier. Smooth, quiet and it was darn near dead square out of the box. Well built...

Very nice...I'm in.

Thanks for all the info. So vanish is generally a polyurethane? So where does Danish and Tung oil fall in the category. Are these considered a stain since they contain oil. I've noticed that both...