Search:

My approach would be to set the nudge to some random number (say 10" or enough to move the yellow completely outside the red) then move the yellow so it is outside. While there, fill it with white,...

I am a woodturner and have made and engraved thousands of pens. Antler engraves to a beautiful gray contrast and generally, a wide variety of settings will work. However, the type of pen and...

I am considering the purchase of a laser for my home away from home. I have owned an Epilog for 14 years and it will continue to be my primary laser and do the bulk of my work. I have a cabin in...

I engrave pens with a laser. PM me for details if interested.

The calls look great. Where can I find the slate and other surface materials for sale?

Wish I had the extra $$. I'd jump on that DVR in a heartbeat at that price.

ALL press fit parts WILL work loose over time. Clips are usually the first part to work loose followed by couplers on screw cap pens. I epoxy ALL parts into place. CA will work, but the gases...

I have had this lathe for about 4 years. I have not had any problems with the drive system and I am on this lathe 10-15 hours per week. The legs on this lathe are very nice - extra heavy with built...

Please count me in. Thanks.

Please count me in.

Please count me in.

Size - what is the largest size shop that you think you will ever need? Now double that and you will still find yourself running out of room in a couple of years ;)

Those look really nice.

Decided to make a few little tops to kill some time.

You already know the answer ;)

Thank you for the comments.

Brian - I turned the platter and then inlaid the shell.

I think you have a winner.

http://www.mestaridesigns.com/images/maplepaua.jpg

Curly maple platter with paua shell inlay

How much will it cost?

It's best not to go there...seriously. Do NOT keep track of what you spend and do NOT add up the total cost at any point in time. And especially, do NOT, I repeat, DO...

http://www.mestaridesigns.com/images/leopsq.jpg
Leopardwood, 6 1/2" X 6 1/2" X 1 1/2"

If I were in your situation, my choice would be based upon the topic of the demonstration rather than the demonstrator because they are all in the must see category.

Finish the smiley face that is partially burned in the bottom ;)

Seriously though, burn a scene that somehow incorporates the little mishap. Or perhaps pierce the entire piece with hundreds of...

A couple of 2008 shows were better than 2007, but most were down from 2007 - at least that was my experience.

I have paid as much as $750 for a booth. Sometimes I leave on the plus side, sometimes in the hole.

As far as I know, most exotic wood in stores is still somewhat green. Some pieces may be drier than others, but it is typically not kiln dried.