I use Orange Blast (citrus engine degreaser multi-cleaner-BJ's, Wallys etc)to clean blades and router bits-soak-or spraybottle on and a lite scrub with a nylon bristle brush or toothbrush-if I soak...
Type: Posts; User: George B. Tracy; Keyword(s):
I use Orange Blast (citrus engine degreaser multi-cleaner-BJ's, Wallys etc)to clean blades and router bits-soak-or spraybottle on and a lite scrub with a nylon bristle brush or toothbrush-if I soak...
Andrew I doodled my perception of what you're trying to accomplish to think it out a bit. I made the drawing kind of quick to get some ideas. I drew it with 1 3/4" diameter legs and 3/4" aprons. In...
I just googled the Hitachi-that's a long reach to off. I'd second Chris' sentiments on a larger base. I have different sized Lexan 1/4"/3/8" thick bases b/c I'm in love with my fingers (all 10 all...
Is there a reason why you wouldn't want to cut "flats" on the round portion of the leg where you will join the apron? Are you tenoning the joint?
David-having just done this for my new MM16 (485lbs)-I searched the board for "mobile base" and there are a ton of options. I ended up using some pricey but excellent casters made by Zambus (then...
I'm still backed up about Festools' "biscuit jointer" with a motor and $XXXX entry fee---I think I'd rather go spend the money on some really expensive Japanese slicks. (Waits patiently)
Got the casters today and had to see what they'd do. They are definitely mobile glides about and finds all the low spots on my lumpy concrete floor.
Measured the table before and after 34 3/4" up...
If you have one of the "Pro" clamp n tool guides (about 5 1/4" wide) clamp it over one of the ends so it overhangs the edge of both sheets and run it through your tablesaw using the guide indexed to...
I don't know if you've seen/heard of this book by Scott Landis-The Workbench Book.
I recently decided I needed a new bench and poured through and compared all the "options" as the book offers...
Thanks for the replies-my MM16 is fresh from the trade show in Hartford on May 3 with a 2007 manufacture date. Thanks to the circumstances of my search I originally thought I could get along with...
Hello fellowwoodworkers.
I've just joined the sight and discovered the Creeks' existance while searching for a new bandsaw. As it were there are a "few" good threads on bandsaws.
I've...