Search:

Great, Thanks for the tip Richard...just the advice I was searching for. I appreciate it.

Eric

Keith, I saw them advertised on Ebay first. Then I checked the Jet Manual and they are shown there. I just put a new conveyor belt on this and spent upwards of about 2 hours trying to get it to...

I recently purchased an older but very used Performax 16-32 Drum Sander that has a few good years left. Like many, I am having the typical conveyor alignment issues, but after tearing down the...

I concur Jim, I didn't like the flex doing through the wall. I think she should have used metal duct with an insulation wrap similar to what is used in the HVAC industry to cover hot and cold...

Check your local Lumber Liquidators, they carry butcher block in a large variety of species that is very economical. I'd go with the 1 1/2" hard maple.

Where are all the people here that always said BUY AMERICAN?

Really nice! Love Canadian made General equipment.

So I posted this on my Facebook page to some of the woodworking groups I belong to there and have gotten rave reviews. I'm not sure anyone has done this, or I have never seen it done, but the idea...

Yes the Bessey Clamps on the left are the ones I bought at HD, they are the newly designed models.

Bought them yesterday...

385658

Bessy K-Body clamps on the net are running about $60. Home Depot had them for $44.97 recently until they lowered the price to 39.97. So I bought 8 of the 50" model. Wouldn't it be cheaper to buy...

I'm very intrigued with the Incra Rules. I have two, the 6" T Rule and the Tiny-T, I don't use them much, actually mine are really brand new, and I've had them for a couple years. I always fall...

Great! I appreciate the information. This is very helpful, thanks so much.

Eric

I noticed SawStop is marketing a new folding outfeed table for use with their SawStop models. Their website shows the outfeet table clamping to the back rail of their fence system which looks very...

Marlin, sometimes Lowes will have a damaged 4'x8' sheet of formica, you can ask for a discount and they will most likely give you one. A sheet comes in handy for all sorts of uses and jigs.

Anyone have a South Bend 7" Shaper with the original South Bend low voltage control option that could help me wire mine up?

Thanks,

Eric

sounds like a $39.00 Skill saw from HD would out-perform the Festool you have. I don't drink from the Festool fountain either...

it is just too expensive to pay that much for a power tool. I'm sure they are good, but I'd rather buy old Makita brand made in Japan, or Bosch, Made in Switzerland in good condition for 1/4 the...

Not a bad deal at all. It would be a better deal if you just commandeered a pickup truck and drove down to the beach to get it. After gas and spending the night you might save $100-200, but you...

I have a bunch of Starrett Squares, a couple Scherr Tumico squares, Lufkin, Brown and Sharpe and Union Tool. Starrett has the best attention to detail, but all are very good. I like my Union the...

I have the Dewalt 20 Volt model, I only bought it to use when I buy lumber at the mill or someone's house and I need to cut it before loading...

What ever you build, watch William Ng's video on YouTube regarding the construction of this crosscut sled. Very good video.

Love this box Charley...Very nice

available on Amazon for $33.00

About 20 years ago, I bit the bullet and bought about 20 Jorgensen I-Beam Clamps 36" Long. They were about $40 each back then, but I am glad I have them. I then bought the standard 5" Bessey clamps...