or nm I will contact Trotec on how to adjust.
Type: Posts; User: Sterling Wong; Keyword(s):
or nm I will contact Trotec on how to adjust.
i'll try the wireframe view
Kevin how do I adjust the tickle issue. Is there a general term for it?
Hello I have run into a strange issue and can't figure out what it is.
If you look at the images there is a "lighter engraving" as if it laser engraved very lightly outside the artwork. this...
I just added images to my first post of the black stains on the table.
I'm not sure if it is actually mold now.
Hello
Last year I made tables out of birch plywood for a restaurant patio however some of the tables have deep black water stains.
I have sanded off the coating and tried oxide paste (bar...
Hi Tony, I am located in Montreal
The laserable aluminum that you mentioned are they black on both sides? The ones I have found are only black on one side and very thin.
They say they don't carry those products
thanks ! I will contact them !
382046
Hi everyone, 382047
Would anyone here happen to know where I can purchase anodized or laserable aluminum sheets. I need the sheet to be black and when laser engraved the artwork comes out...
Yes they might be used a few times every summer about a few days to a week for each event
Im leaning towards the varnish that I postednow deciding to use water or oil based
I would like to have...
I won't be staining them, just need to put a durable finish on it because they'll be cleaned often from rags / water etc. These are temporary tables used during a weekly event that happens a few...
Thank you for the suggestions everyone
Hello what would be an acceptable budget finish for a wooden table to be used outside a restaurant. They will be used for 1 week only and will be cleaned by waiters all day. A salesman told me I...
Hello everyone,
I have a project coming up to make an exterior sign for a restaurant. Im planning to make it either engraved and colorfilled on a wooden board or a 3d sign woth the letters cnc'd...
i realize I posted in the wrong forum, will make new post in the woodworking projects forums
We haven't spoken about the budget yet, I'm seeing if it's something I can do first. We have snow and ice here, afraid of damage from the ice / water expanding in the sign
Hello everyone,
I have a project coming up to make an exterior sign for a restaurant. Im planning to make it either engraved and colorfilled on a wooden board or a 3d sign woth the letters cnc'd...
ok so I won't take a chance with water based stains. How about oil based stains?
Hi everyone I am in need of advice
I have a project to make serving plates for a restaurant
Im using birch plywood and ill be staining them with Saman water based stains.
How do I make sure it...
Im using the standard lens that came witg the trotec. Not sure what it is but probably a 2.5
And yeah plexiglass for example i usually dont do one pass to go through
I go slow speed low power...
Ok so you guys are saying a software isn't necessary to laser cut for example a 3/8 thick plexiglass?
I understand it wont be as flat as machining it but as long as it doesn't come out slanted
I have also tried lowering the focus after each pass but the results are not very nice
It seems the edges on certain sides get "shifted" to another direction
Hi all I dont remember if ive ever asked this but is there a manual technique or free software to manipulate the laserachine to cut thick materials with a flat edge?
I have been told by...
Hi everyone
I'm looking for suppliers in Canada, preferably in Montreal that supply promotional products. Mostly bamboo / anodized aluminum stuff. I'd get them from China but I don't need huge...
Hehe looks like I'm too late, not able to reply post in that page
I was aware of Vectrix
On the Probotix page they suggested Artcam express for 149$ and meshcam I think it goes for around 200$...