Get someone to help with the weight on the outfeed side. I'm building an outfeed table for my Rikon 10-325 for the same purpose. Some of my logs are 6' x 12"
Type: Posts; User: Steven Hess; Keyword(s):
Get someone to help with the weight on the outfeed side. I'm building an outfeed table for my Rikon 10-325 for the same purpose. Some of my logs are 6' x 12"
Get my Red Oak, White Oak, Maple, Tulip Poplar, and Loblolly Pine (Southern Yellow) out of my back yard!. Saw it up on the sawmill, then bandsaw, then every tool that's needed.
Ok, newb here. It seems to me that a router table set up is basically the same thing as a shaper. Yes? No? Can you tell me the differences and advantage of each?
Thank you.
Steve
The impeller is quite heavy, assuming because it can crush 2" limbs. I could theoretically idle it down, but would see no point in that. Would run it at normal top speed to get max airflow. I don't...
Rikon Tech Support states the tension gauge is their as a feel good indicator. My stock 1/2" blade is tensioned about a 1/3 of the way past the 5/8" blade setting. That's good for that blade. Do the...
Might want to consider Rikon 10-325 14" deep with 13" resaw ability. Has cast iron wheels and heavy cast aluminum trunnion. When I called Rikon about the trunnion, they said they haven't ever had a...
The 2 Large washers are 5/16"ID and 1 1/16"OD and they are supposed to be mounted between the middle shelf in front and the base frame to shim so when you tighten the bolt they don't pull the metal...
The only info I can get is that it sucks with 80mph air. What would that equal in cfm through a 6" duct?
After reading Bill Penz' website, I'm convinced venting outside is the prudent measure. I would install 6" sd pipe throughout and this would just be temporary for the suction end. The chipper doesn't...
It's a self contained gas powered direct drive chipper with impeller and collection box on wheels (pull with garden tractor,atv,etc.)all together. Literally, would just have to hook up to ducting and...
No that would be it's own setup. Just chips and dust. Planning on venting outside no matter what system gets installed.
Pretty sure I haven't seen this done. I have a yard vac/shredder/chipper 8 3/4hp gas with 7" intake. It will suck up 2" limbs and crush them with ease, leaves and such no problem. Question: Could...
Hello all. I'm late coming to the woodworking game, but better late than never.
I'm planning on a Roubo variation as my first project after the woodshop extension and more sawhorses. My question is...
I just finished putting mine together. Have to clean and align still. I had two large washers left over, but couldn't find anywhere in the manual that talks about them. Didn't like the small metric...
If it is the 1st panel immediately off the meter, then it is the main panel and ground and neutral will be the same or the bars will be bonded to each other. If the panel is fed from another panel,...