Page 2 of 2 FirstFirst 12
Results 16 to 18 of 18

Thread: HTC Outfeed Tables/Uniguard

  1. #16
    Join Date
    Jan 2005
    Location
    Waterford, MI
    Posts
    4,673
    Quote Originally Posted by Steven Wilson
    I had the HTC outfeed rollers on a Powermatic 66 and they worked very well. The unit attaches at two places along the back of the cabinet. Nothing attached to the saw at the back of the table top. I'm not sure if they would work with the guard you're describing. Have a picture?
    Steve
    I was searching thru posts as I'm contemplating the exact same HTC roller setup on my PM66. Just curious why you HAD (instead of have) the setup. Did you switch to a different saw or did you end up getting rid of the roller setup? And if so, why did you end up removing it?
    Use the fence Luke

  2. #17
    Join Date
    Sep 2003
    Location
    Grand Marais, MN. A transplant from Minneapolis
    Posts
    5,513
    Quote Originally Posted by Doug Shepard
    Steve
    I was searching thru posts as I'm contemplating the exact same HTC roller setup on my PM66. Just curious why you HAD (instead of have) the setup. Did you switch to a different saw or did you end up getting rid of the roller setup? And if so, why did you end up removing it?
    OOOOH he switched alright.
    TJH
    Live Like You Mean It.



    http://www.northhouse.org/

  3. #18
    Hey guys, I think Steve sold his saw and bought something bigger.

    John

Similar Threads

  1. Table Saw outfeed table question???
    By Dan Smith in forum General Woodworking and Power Tools
    Replies: 19
    Last Post: 02-19-2005, 10:26 AM
  2. Shop-made outfeed rollers
    By Mark Kelly in forum General Woodworking and Power Tools
    Replies: 8
    Last Post: 05-14-2004, 10:50 PM
  3. Drop Down Outfeed Table?
    By Joe Suelter in forum General Woodworking and Power Tools
    Replies: 5
    Last Post: 12-23-2003, 5:59 PM
  4. Finish for TS outfeed table
    By Tom Hamilton in forum General Woodworking and Power Tools
    Replies: 8
    Last Post: 12-16-2003, 7:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •