I just purchased the Wolverine system by Oneway and I have some questions. First one is grinder speed. I know that I have read or heard somewhere that slower is better, not according to Oneway. They recommend a 8" grinder turning at 3450 RPM. I have a 6" grinder that turns at 3450 RPM but their instructions says thats to slow.....comments please.
Next is the chose of stones and grit size. I have the white in a 100 grit but here again they say that should only be used for small turning tools. Is there one or two stones that will cover all the different tools?
And finally is the angle of the grind. The little tri-gauge I purchased recommends 35 degrees for a bowl gouge???????? Is that ALL bowl gouges? Shallow and deep fluted. What about the Ellsworth? I know that I have got that angle off over the last few month by just freehand grinding. what is the correct angle for it?
Thanks in advance. I am sure that I will get lots of help.