Sorry for the newbie question but my resident expert is on vacation. I was trying to engrave a name into a plastic pelican flashlight today but I was unable to set the height of the flashlight. I did lower the table but when I tried to allow for the 1.5" height of the flashlight I was unable to select custom in fixture type. I believe that I was shown that the place to set this was in (fixture type, universal control panel under settings). So long story short when I said go, the table bed rose up and knocked the flash light over.
So long story short how do I get the program to let me select a different fixture type. The program at this time will not allow me to select it, but earlier today my tech showed me that he could do it.
John Kidd