Hello hope you can give me some help,,

I purchased two machines with the software to run them, but it is not too user friendly (dos/windows). I have engraved some lines of text. I am wanting to do some dimensional milling, like grape bunches, dimensional lettering and relief cuts.

I have been looking on the internet for infomation on changing these two machines to either mach3 or emc2 but they have a pretty good learning curve too. I would like a more friendly windows work invironment if it is possible, that does not cost an arm and a leg.

I use CorelDraw8 and x3, I purchased winpcsign as it had a driver for the 9000 but I have not been able to get it working.


Will I have to change anything else to get it up in running in a 21st century windows environment.

Any help would be appreciated

Thanks, : ) Mark

Neeley Graphics
Signs & Designs
Bellbrook, Ohio