I'm planning to get a 23-gauge pin nailer but am faced with a bewildering choice of nail lengths to get. For the nailer I'm looking at the range is 1/2 to 1 3/8 inches in increments of 1/16 inch. I'll probably get some headless and some slight-headed ones. For the typical uses of these nailers--crown, delicate trim, etc--what are useful lengths? I was hoping to get no more than two or three lengths. Are the really short ones like 1/2" all that useful? And do you ever use 1 3/8" or do you just figure that if you need something that long you're better off with an 18-gauge brad nailer instead?
--Rob