Looking for a 45 degree burr

[David Fairfield]

Hi

I am looking for a burr that has a 45 degree cutting surface. Basically I want to run some thin (2mm) wood veneer through a shaper table and produce a 45 degree chamfer to the edges. A router cutter tended to splinter the edge, so that's why I'm looking for a burr.

I looked at a bunch of tool catalogs, couldn't find the sort of burr I needed. Any help appreciated!

Thanks!
Dave

[Paul Atkins]

How about a 'shooting board' and use a sanding block instead of a plane?