MY 7518 conked out today. just started running slower then stopped.
I think it might be brushes but who knows. i ordered a new one from amazon for $350 I hope i get more than 6 months out of this one.
[OP]
Member
MY 7518 conked out today. just started running slower then stopped.
I think it might be brushes but who knows. i ordered a new one from amazon for $350 I hope i get more than 6 months out of this one.
[SIGPIC][/SIGPIC]Camaster Cobra 408 working table size 48 x 98
Wincnc,AspireII,PhotoVcarve,Cut3D
HX6090SE 60Wworking table 23”X36”
LaserCut 5.3
Coreldraw X3, photograV 3.0, Photozoom3
Sawmill Creek is financed in part through member contributions.
Many members just like you have found extraordinary value in becoming a financial supporter of SMC.
Friend of the Creek
james the 7518 is a horse and yes it will be brushes and eventually a bearing, i have two that are over 9 years old that are still kicking well
call tyler at mann tool 803 252 7777 they can ship you the parts
jim
[OP]
Member
JIM M. thanks for the advice. MY new router showed up about 2 hours ago; I have already installed it and ran a small job. all is well. I ordered replacement brushes for the dead one. I will keep that as a back up. Jim J.Originally Posted by james mcgrew
[SIGPIC][/SIGPIC]Camaster Cobra 408 working table size 48 x 98
Wincnc,AspireII,PhotoVcarve,Cut3D
HX6090SE 60Wworking table 23”X36”
LaserCut 5.3
Coreldraw X3, photograV 3.0, Photozoom3
Sawmill Creek is financed in part through member contributions.
Many members just like you have found extraordinary value in becoming a financial supporter of SMC.
Member
I have had better luck with the brushes and bearings since I turned down the rpm to 10,000 or 12,000 and in some case had a better finish and with less nosie
Ed
probitix cnc Corel x3, Vcarve pro6.0, Aspire4.0
Posting Permissions
Reply With Quote