I recieved my laser on the 11th and have been using it with the 64-bit driver. It works just fine. I have saved a few settings and would like to access them. Does anyone know how to do this. I suspect they need to be in a particular directory.
On the 32-bit version its in the Documents\epilog\engraving_setting. You can even change it.
This does not seem to be the case with the 64-bit driver. Unless I can get this to work it sets me back as I will have to go back to square one again.
I though about loading the settings up in the 32-bit driver but it wont read them. Does not look like the settings files are compatible with one another which is a real bummer.