Hi all, another question, for this here techno-idiot.
I have an new fax/scan/laser printer (HPM1319 MFP), connected to my laser engraving computer by USB.
My epilog is hooked up by ethernet.
I have a dedicated fax line.
I had no problems, until I used the epilog.
The fax had quit receiving. It would send, scan, copy stuff as normal, but wouldn't receive. I didn't even notice.
I've tweaked the fax again this morning. It's receiving again.
Once I turn on my epilog, I just know the issue will re-surface. (I'm psychic).
When I used the epilog, I did notice the first job didn't go to the laser. I had to re-select my epilog as the printer.
Makes sense.
But by doing so, I think I'm kicking the fax off....
Oye.
I wish I hadn't decided to quit coffee.
Off to look at default settings again.
Thanks for any/all suggestions.
I need to boot Abigail (epilog legendEXT 60 watt) up.
And of course, thanks to Frank and all of you brilliant people on the Creek.
I've been lurking more. Questions are usually answered in the searches.
Wax on, wax off.
The Creek Rules!