My Shop-Built TS Outfeed Table

[Jason Hanko]

I did add one feature since making the outfeed table - Ive added a cable that stops/holds the leg at the right height when folding it up/down. Originally the hinged leg would swing all the way down to perpendicular when you undid the lock-bolt that holds it in place. Ive put since put eyehooks in the bottom of the table and on top of the leg, and ran steel wire between the two at the right length that it holds the leg at just the right height to sit on its shelf.

Its funny to see this old post "rise from the dead" and be back on the first page of the forum. (Just for reference, heres a picture of that same shop helper now, next to his own workbench and project) :2012-11-11 11.40.41.jpg

[John Petsche]

nice idea and modification to mount to mobile base. Thanks for the great photos.

John

[johnny means]

Next week he'll be asking for the keys to your car.

[Ole Anderson]

I made one from the same plans, although I felt their support leg was way too complicated. Kept mine a bit smaller due to my tight shop.