I am about to put the final coat of Arm-R-Seal on a bubinga table top and need some help. The top was filled with oil based filler prior to finishing. I applied a coat of Seal-A-Cell then started with Arm-R-Seal gloss. I applied 5 coats, sanding in between with 400grit between the first 2 coats, then with 600grit and mineral spirits between the next 2 coats.
For the final coat, should I sand, and if so, with 400grit or the 600grit and mineral spirits?
Should I wipe on and immediately wipe off the final coat or, wipe on or foam brush a final coat and leave it to dry withou wiping it off?
Finally, I feel the satin is too satin. Should I add some gloss to the satin to reduce the satin effect?
I would appreciate any help you experienced finishers can provide.
Many thanks, Mike