I have a file that is saved as 2007 dwg that I need saved as a 2000 so I can open it and work on it.
Is there anybody out in Creeker land that can help me out?
I have a file that is saved as 2007 dwg that I need saved as a 2000 so I can open it and work on it.
Is there anybody out in Creeker land that can help me out?
[SIGPIC][/SIGPIC] Hope you all got a nice stash. Because this was seized at the border today.
I think I can help, I sent a PM.
Lee Schierer
USNA '71
Go Navy!
My advice, comments and suggestions are free, but it costs money to run the site. If you found something of value here please give a little something back by becoming a contributor! Please Contribute
Send it on . . .
P.M. Me . . .
Steve
Support the "CREEK" . . .
Mike, if they can't convert it, let me know, because I'm sure I can. Just so you know, Autodesk has a free program that converts (down or up) any .dwg file. I think they call it True View now.
Brian
It’s only work if somebody makes you do it.
A day can really slip by when you're deliberately avoiding what you're supposed to do.
Duct tape is like the force. It has a light side, a dark side and it binds the universe together.
Thanks so much guys.
I sent the file to Lee.
Brian I am going to look into that program right now. Thanks for the heads up.
Mike
[SIGPIC][/SIGPIC] Hope you all got a nice stash. Because this was seized at the border today.
TrueConvert is available as a free utility at Autodesk's website for just this purpose.
-Jeff
Thank goodness for SMC and wood dough.
I down loaded true view today. I did not get a chance to try it but will in the morning.
If true convert is the program I am looking for I will down load tomorrow.
Thanks creekers.
It's funny what you don't know and have no idea about until you ask.
[SIGPIC][/SIGPIC] Hope you all got a nice stash. Because this was seized at the border today.